Laserfiche WebLink
2018 WSEC Requirements for Commercial Buildings including Group R2, R3 & R4 over 3 stories & all R1 -- Administered by 02024 NEEA, All rights reserved <br />The following information is necessary to check a mechanical permit application for compliance with the mechanical systems and equipment requirements in the <br />Washington State Energy Code, Commercial Provisions. <br />For questions about this report, contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br />C403.9 2.2 Steam condensate <br />systems heat rec>very <br />C403.0.2.3 Refrigeration <br />condenser heal <br />recovery <br />C403.9.2.4 <br />Heat recovery for <br />space heating <br />C403.9.2.4,1 <br />Water to water heat <br />C403.9.2.4,4 <br />recovery <br />C403.9.2.4.2 <br />Exhaust heat recovery <br />C401.9 2.43 <br />ProeesS heat rcarvery <br />MULTIPLE ZONE AIR SYSTEMS <br />I -or building, with on -site steam healing <br />systems, indicate condensate water heat <br />recovery and use of recovered heat <br />For buildings that use off -site generated steam <br />where condensate is not returned to the <br />source, indicate on -site condensate water heat <br />recovery <br />For buildings with food service. meat or deli <br />departments that have >_ 500.000 Btu/h of <br />remote refrigeration capacity for coolers ! <br />freezers. indicate condenser heat recovery and <br />use of captured energy (service water heating. <br />space heating. or dehumidification reheating) <br />For buildings with > 40.(1(K) sf conditioned <br />floor area and ? 1.000.000 Bluth of remote <br />refrigeration capacity. indicate condenser heat <br />recoyery to pre -heat service water: indicate <br />remaining recovered heat is applied to space <br />heating or dehumidification reheating <br />For buildings that operate > 70 hour per week <br />that are not served b) a DOAS with energti <br />recover)', and have > 1,500.000 Btu/h of heat <br />rejection capacity and >_ 0.45 efm per sf of <br />design minimum supply airflow with reheat, <br />indicate condenser heat recovery is provided <br />for space heating that complies with Sections <br />C403.9.2.4.1 or C403.Q.2_4.2 or C403.9.2.4.4 <br />Indicate that 90q or more ol'the total <br />building space heating and ventilation air <br />design loads are served by heat energy <br />r11ected from either a heat recovery chiller or <br />the cooling loop of water to water heat pump <br />equipment <br />Indicate that waste heat is recovered from <br />least 901% of the total building exhaust airPiow <br />such that leaving exhaust air temperature <br />while in heat recovery mode is 55 deg P dry <br />bulb; note exhaust air Systems eligible for <br />exception to this requirement <br />In spaces with 5 watts per sf vear-round <br />coolina loads I rom lights and equipment. <br />indicate these spaces are served by water- <br />cooled equipment configured for heat <br />recover\ <br />If these spaces are served by economizer (air <br />or water), indicate automatic controls are <br />configured to disable economizer operation <br />while system is in heat recovery mode <br />Page 18125 <br />