Laserfiche WebLink
2018 WSEC Requirements for Commercial Buildings including Group R2, R3 & R4 over 3 stories & all R1 -- Administered by @2023 NEEA, All rights reserved <br />The following information is necessary to check a permit application for compliance with the lighting systems, motors and electrical system requirements in the <br />Washington State Energy Code, Commercial Provisions. <br />For questions about this report, contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br />Demonstrate that proposed wattage per non - <br />tradable surface type does not exceed <br />I <br />maximum allowed wattage per non -tradable <br />surface type (including base site allowance <br />remaining after tradable allowance <br />calculation); identify locations of non -tradable <br />surfaces on plans; provide WSEC exterior <br />lighting compliance reports <br />LIGHTING ALTERATIONS <br />YES . <br />C503.6.1 <br />Interior and parking <br />Where >— 50% of existing luminaires in an <br />E Sheets <br />garage lighting <br />interior space or parking garage are replaced; <br />fixture alterations <br />indicate compliance path (building area or <br />space -by -space method); include all new and <br />existing -to -remain luminaires in WSEC <br />interior lighting compliance reports; indicate <br />proposed lighting wattage does not exceed <br />maximum allowed per compliance path <br />NA <br />Where < 50% of existing luminaires in an <br />interior space or parking garage are replaced; <br />indicate total existing lighting wattage in each <br />space prior to alteration; include all new and <br />existing -to -remain luminaires in WSEC <br />interior lighting compliance reports; indicate <br />proposed total lighting wattage in alteration <br />area does not exceed total existing lighting <br />wattage prior to alteration <br />Where >_ 50% of existing exterior lighting <br />wattage is replaced; include all new and <br />existing -to -remain luminaires in WSEC <br />exterior lighting compliance reports; indicate <br />proposed total exterior lighting wattage does <br />not exceed maximum allowed <br />Where < 50% of existing exterior lighting <br />I <br />wattage is replaced; indicate total existing <br />lighting wattage prior to alteration; include all <br />new and existing -to -remain luminaires in <br />j <br />WSEC interior exterior compliance reports; <br />i <br />indicate proposed total exterior lighting <br />wattage does not exceed total existing wattage <br />prior to alteration <br />YES <br />C503.6.2 <br />Interior lighting <br />Where new wiring is installed to serve new <br />E Sheets <br />wiring and circuiting <br />interior luminaires and /or luminaires are <br />alterations <br />relocated to a new circuit; indicate manual <br />and automatic lighting controls are provided <br />(as applicable) - manual (C405.2.3); <br />occupancy sensor (C405.2.1); light reduction <br />(C405.2.3); daylight responsive (C405.2.4); <br />specific application (C405.2.5) <br />Where new wiring is installed to serve new <br />exterior luminaires and /or luminaires are <br />relocated to a new circuit; indicate automatic <br />lighting controls are provided (C405.2.6) <br />Page 7110 <br />01/01,13 <br />