Laserfiche WebLink
Refer to the following diagram to ensure proper distance from walls and ceiling: <br /> 15cm (5.9in) or more <br /> I <br /> II <br /> 12cm (4.75in) 12cm (4.75in) <br /> or more or more <br /> �Q i / <br /> ..o <br /> d 0 <br /> 't C <br /> 0 <br /> 7 3 <br /> 2.3m (90.55in) or more <br /> Fig.3.1 <br /> Step 2: Attach mounting plate to wall Step 3: Drill wall hole for connective piping <br /> The mounting plate is the device on which you You must drill a hole in the wall for refrigerant <br /> will mount the indoor unit. piping, the drainage pipe, and the signal cable <br /> 1. Remove the screw that attaches the mounting that will connect the indoor and outdoor units. <br /> plate to the back of the indoor unit. 1. Determine the location of the wall hole based <br /> 2. Place the mounting plate against the wall on the position of the mounting plate. Refer <br /> in a location that meets the standards in to Mounting Plate Dimensions on the <br /> the Select Installation Location step. (See next page to help you determine the optimal <br /> Mounting Plate Dimensions for detailed position. The wall hole should have a 65mm <br /> information on mounting plate sizes.) (2.5in) diameter at least, and at a slightly <br /> 3. Drill holes for mounting screws in places that: lower angle to facilitate drainage. <br /> have studs and can support the weight of 2. Using a 65mm (2.5in) or 90mm(3.54in) <br /> • (depending on models )core drill, drill a <br /> the unit hole in the wall. Make sure that the hole <br /> • correspond to screw holes in the mounting is drilled at a slight downward angle, so <br /> plate that the outdoor end of the hole is lower <br /> 4. Secure the mounting plate to the wall with than the indoor end by about 5mm to 7mm <br /> the screws provided. (0.2-0.27in). This will ensure proper water <br /> 5. Make sure that mounting plate is flat against drainage. (See Fig. 3.2) <br /> the wall. 3. Place the protective wall cuff in the hole. This <br /> NOTE FOR CONCRETE OR BRICK WALLS: protects the edges of the hole and will help <br /> seal it when you finish the installation process. <br /> If the wall is made of brick, concrete, or similar <br /> material, drill 5mm-diameter (0.2in-diameter) 0 CAUTION <br /> holes in the wall and insert the sleeve anchors <br /> provided. Then secure the mounting plate to When drilling the wall hole, make sure to <br /> the wall by tightening the screws directly into avoid wires, plumbing, and other sensitive <br /> the clip anchors. components. <br /> Page 12 ► <br />