Laserfiche WebLink
• <br /> If refrigerant piping is already embedded in 3. Connect drain hose and refrigerant piping <br /> the wall, do the following: (refer to Refrigerant Piping Connection <br /> 1. Hook the top of the indoor unit on the upper section of this manual for instructions). <br /> hook of the mounting plate. 4. Keep pipe connection point exposed to <br /> 2. Use a bracket or wedge to prop up the unit, perform the leak test (refer to Electrical <br /> giving you enough room to connect the Checks and Leak Checks section of this <br /> refrigerant piping, signal cable, and drain manual). <br /> hose. Refer to Fig. 3.11 for an example. 5. After the leak test, wrap the connection point <br /> with insulation tape. <br /> 6. Remove the bracket or wedge that is propping <br /> up the unit. 5 Q <br /> 7. Using even pressure, push down on the v o <br /> W bottom half of the unit. Keep pushing down 3 3 <br /> uilt4J_ edge <br /> until the unit snaps onto the hooks along the <br /> bottom of the mounting plate. <br /> i11#1)I1)J1 <br /> 1/11 <br /> IMP <br /> 11.11 <br /> MO <br /> Fig.3.11 <br /> UNIT IS ADJUSTABLE <br /> Keep in mind that the hooks on the mounting plate are smaller than the holes on the back of the <br /> unit. If you find that you don't have ample room to connect embedded pipes to the indoor unit, the <br /> unit can be adjusted left or right by about 30-50mm (1.25-1.95in), depending on the model. (See <br /> Fig. 3.12.) <br /> 30-50mm 30-50mm <br /> (1.2-1.95in) (1.2-1 .95in) <br /> 4 ► ( 110 ) 4 ► <br /> \ ' / <br /> Move to left or right <br /> Fig.3.12 <br /> 4 Page 19 ► <br />