Laserfiche WebLink
WARNING PAY ATTENTION TO LIVE WIRE <br /> While crimping wires, make sure you clearly <br /> BEFORE PERFORMING ANY ELECTRICAL distinguish the Live CO Wire from other wires. <br /> OR WIRING WORK, TURN OFF THE MAIN <br /> POWER TO THE SYSTEM. <br /> 1. Prepare the cable for connection: WARNING <br /> ALL WIRING MUST PERFORMED STRICTLY <br /> USE THE RIGHT CABLE IN ACCORDANCE WITH THE WIRING <br /> • Indoor Power Cable (if applicable): HO5VV-F DIRGRAM LOCATED INSIDE THE OUTDOOR <br /> or H05V2V2-F UNIT'S WIRE COVER. <br /> • Outdoor Power Cable: HO7RN-F 2. Unscrew the electrical wiring cover and <br /> • Signal Cable: HO7RN-F remove it. <br /> Minimum Cross-Sectional Area of 3. Unscrew the cable clamp below the terminal <br /> Power and Signal Cables block and place it to the side. <br /> North America 4. Match the wire colors/labels with the labels on <br /> o the terminal block, and firmly screw the u-lug <br /> a a Appliance Amps (A) AWG of each wire to its corresponding terminal. <br /> OJ <br /> ♦° 5. After checking to make sure every connection <br /> 10 18 is secure, loop the wires around to prevent <br /> 13 16 rain water from flowing into the terminal. <br /> 18 14 6. Using the cable clamp, fasten the cable to the <br /> 25 12 unit. Screw the cable clamp down tightly. <br /> 30 10 7. Insulate unused wires with PVC electrical tape. <br /> Arrange them so that they do not touch any <br /> Other Regions electrical or metal parts. <br /> 8. Replace the wire cover on the side of the unit, <br /> Rated Current of Nominal Cross- and screw it in place. <br /> Appliance (A) Sectional Area (mm2) <br /> > 3 and <_ 6 0.75 <br /> > 6 and <_ 10 1 <br /> > 10 and_< 16 1.5 <br /> > 16 and<_25 2.5 Cover-, o <br /> > 25 and <_32 4 <br /> > 32 and <_40 6 <br /> a. Using wire strippers, strip the rubber <br /> jacket from both ends of cable to reveal %�(•0 <br /> about 40mm (1.57in) of the wires inside. ro1111-4,' <br /> b. Strip the insulation from the ends of the <br /> wires. <br /> c. Using a wire crimper, crimp u-lugs on the <br /> ends of the wires. Outdoor Unit Wiring Diagram <br /> is located on the inside of the <br /> wire cover on the outdoor unit. <br /> Fig.4.6 <br /> 4 Page 24 ► <br />