Laserfiche WebLink
Previous build #2205-3 <br />BraunNW (jg/jw) 19 of 34 Everett Fire Dept. <br />5-5-25 Original build #/2205-3 Remount Specification <br /> <br /> . <br />5 MODULE INTERIOR <br />5.01T UPPER WALL COVERING <br />Transfer existing wall covering. <br />5.02T HEADLINER <br />Transfer existing headliner. <br />5.03T HEAD PADS/CUSHIONS <br />Transfer existing head pads with existing upholstery. <br />5.04T LOWER WALL COVERING <br />Transfer existing covering. <br />5.05T GRAB RAIL <br />Transfer one existing grab rail, with wire hooks, centerline above cot. <br />5.06X ACCESS DOOR GRAB RAILS <br />Remove and return existing 18” yellow grab bar from Curbside Squad Bench #11 (Section <br />8.03 related). <br />Transfer all existing door grab rails on all entrance doors except the curbside passage door. <br />Install one new Yellow powder coated L-shaped stainless steel grab bar on the curbside <br />passage door. <br />Transfer one existing grab rail forward of Curbside Squad Bench with Storage #11 <br />Transfer one existing grab rail installed at an angle on Cabinet #16 <br />5.07T IV HANGER <br />Transfer one existing IV hanger streetside above foot of cot. <br />Transfer existing wire hooks on overhead grab rail. <br />5.08T COT MOUNT <br />Transfer existing cot mount in same position. <br />Transfer existing floor plate for rear rail clamp. <br />5.11T ELECTRIC OXYGEN SYSTEM <br />Transfer and low pressure test existing oxygen system including the following <br />•One LED display with manual bypass on the forward facing wall, aft of Curbside <br />Squad Bench with Storage #12. <br />•One outlet in Action Area #5 <br />•One outlet above the Curbside Squad Bench with Storage #11 <br />•One outlet recessed in ceiling above cot, streetside, center <br />Oxygen controlled by the ″ELECT. 02″ switch in attendant control panel (Section 6.13 <br />related). <br />5.12T SUCTION PUMP <br />Transfer existing plumbed suction pump in Cabinet #12 <br />Suction pump controlled by the ″SUCTION″ switch in attendant control panel (Section <br />6.13 related). <br />5.13T SUCTION COLLECTOR <br />Transfer existing suction system in Action Area #5.