200 W MARINE VIEW DR ON TRAC LOGISTICS 2025-09-16

VDAIKIPJ Submittal Data Sheet BRC1 E73 - Navigation Remote Controller Project Name: Location: Approval: Engineer: Date: Submitted to: Construction: Submitted by: Unit#: Reference: Drawing#: 11. Airflow—Individual air flow direction, dual airflow and auto draft prevention (prevents air blowing directly on occupants)* 12. Built-in 7, 5+2, 5+1+1 and 1 (Everyday) schedules with up to 5 actions per day with independent cooling and heating or setback setpoints 13. Automatic Setback by occupancy sensor* 14. Automatic Off by occupancy sensor* 15. Configuration for Self-cleaning filter panel** 16. Automatic adjustment for Daylight Savings Time (DST) 17. 48 hour clock/calendar battery backup (protects schedule timing in cases of short term power loss from indoor unit) 18. Real-time monitoring of system malfunctions with immediate display of unit in error and error code 19. The buttons on the remote controller are selectable by locking out the unwanted buttons 20. The operation modes can be restricted to provide only the desired mode(s) of operation 21. Display can be configured to show "Off" and room temperature only when indoor unit is turned off 22. To prevent unwanted changes,fan speed selection and display may be hidden 23. Auto off timer configurable in 10 minute increments (range 30-180 minutes) 24. Can be used to replace earlier versions of remote controllers *Available for FXFQ_TVJU and FXUQ_PVJU indoor units **Available for FXTQ_TVJU indoor units Auto changeover: Automatic changeover is available for Heat Pump system and Heat Recovery systems. The setpoint for cooling and heating are configurable with a minimum differential of 0 to 7°F or single setpoint. The changeover is automatically controlled to happen in either of the following two cases: Case 1: Changeover at the primary changeover temperature after the guard timer expires. 1. In default,the primary changeover setpoint is 1°F above cooling setpoint or 1°F below heating setpoint, which is configurable between 1°F—4°F. 2. In default,the guard timer is 60 minutes, which is selectable among 15, 30,60(default) or 90 minutes. 3. The initiation of guard timer is built in to help prevent frequent changeover which may cause energy loss. Case 2: Changeover at the secondary changeover temperature. 1. In default,the secondary changeover temperature is 1°F above the primary changeover temperature for cooling or 1°F below the primary changeover temperature for heating, which is configurable between 1°F—4°F. 2. Case 2 will happen while the guard time is active in case 1. Daikin North America LLC,5151 San Felipe Suite 500,Houston,TX 77056 Daikin North America LLC Controls Engineering Department Generated Submittal Data www.daikinac.com (Dalkin's products are subject to continuous Improvements.Dalkin reserves the right to modify product design.specificalons and Information in this data sheet.,ithout notice and without incurring any obligations)