Laserfiche WebLink
E-Z ANCHOR INSTALLATION METHOD <br /> Note: With machine installation, a Minute-Man adapter designed to fit both the anchor head and drive machine <br /> shaft is available. Installers do not need additional or special equipment for E-Z Anchor Installation. <br /> E-Z Anchors are a patented item. <br /> 1. MACHINE INSTALLATION <br /> The drive machine is started and the anchor MAX 10° <br /> is turned into the ground to a point where the Stabilizer <br /> top (stabilizer head plate) is flush with or Head <br /> slightly below ground level. This assures that � <br /> the E-Z Anchor Stabilizer will be at its 4.:JI <br /> required installation position. See Figure A. <br /> To achieve full potential, install the E-Z <br /> Anchor vertically. A 10°deviation from <br /> vertical is acceptable. See Figure A. <br /> Note: A slightly greater angle may be used to start <br /> anchor to avoid contact with the home and <br /> straightened as anchor is ground set. The splitbolt is <br /> inserted, strap is fastened, and tightening adjustment <br /> made. <br /> E-Z Anchor carries U.S. Patents and <br /> manufacture is exclusive to Minute-Man <br /> Anchors, Inc. <br /> Figure A <br /> 2. STANDARDS FOR INSTALLATION <br /> • E-Z Anchors and all components are to <br /> be installed per manufacturer's <br /> instructions. <br /> • E-Z Anchors are approved for designated <br /> Soil Class III, IV. <br /> • E-Z Anchor working load capacity is <br /> 3,150 pounds for a single tie or the load <br /> of (2) ties combined.. See Figure B. <br /> • Consult manufactured home set up o� <br /> instructions for number of frame tie MAX 45 Stabilizer Head <br /> downs, over the roof tie downs and tie . ° r;-' <br /> down spacing. <br /> • Proper site preparation requires removal <br /> of grass and sod prior to installation. <br /> Figure B <br /> For additional information, copies of engineering test(s) and report, <br /> Contact Minute-Man Anchors, Inc. <br /> 5. <br />