Laserfiche WebLink
The comments below were generated from this project's City of Everett Traffic Engineering Reviewer. All questions shall be routed through this project's <br />Public Works Reviewer Thad Newport with City of Everett Permit Services (TNewportC@everettwa.gov). <br /># <br />Document <br />Sht/Pg <br />Reviewer's Comment <br />Designer's Response <br />Initials <br />6. Please show all of the work being done on the IL and TS sheets <br />on this sheet including but not limited to the service cabinet <br />being installed as well as the conduit runs into the existing signal <br />junction boxes, and the traffic signal loops to ensure there are <br />no conflicts in this work area. <br />7. Please remove the information about the proposed 22x12x12 <br />junction COE junction boxes and show the information that is on <br />the IL1 and TS1 on this sheet to properly show the tie ins to the <br />COE illumination system. <br />8. Please show the existing pole being removed with its <br />foundation being removed entirely and conduits cut off 24" <br />below grade. <br />9. Please show the new pole being installed in line with the old <br />pole but approximately 5-10' to the north to clear the existing <br />foundation and to move the new small cell pole further away <br />from our existing COE signal pole and equipment. <br />10. Please add a callout to the existing illumination run heading <br />north saying "(E) Direct -Buried Wire (Approximate Location, <br />Contractor to field verify)" <br />4 <br />A-3 <br />1. Please make the information shown on the A series sheets <br />corroborate with the pole shop drawings, and the work being <br />done on the IL and TS sheets. Comments 2-5 explicitly deal with <br />making sure no conflicting information is being shown in <br />different sheet series. <br />2. The existing pole has a 30' luminaire mounting height as <br />shown on this sheet, however the Valmont pole shop drawing is <br />calling for a luminaire mounting height of 35'. Please submit <br />complete Valmont pole and luminaire arm shop drawings for a <br />pole with 30 mounting height. <br />3. There is cabinet enclosure information (festoon box) shown <br />on these sheets as well as the RF series sheets that are not <br />shown in the Valmont pole and luminaire shop drawings. Please <br />Page 4 of 10 <br />