Laserfiche WebLink
Project Name: <br /> LAGILITE Fixture Schedule: <br /> LED LIGHTING www.DigiLiteLED.com <br /> Bypass T8 <br /> Electrical and Technical Data (subject to change without notice) <br /> Ordering Code Bare Lamp Initial Lumen Base CRI Color • .- <br /> 1_48T8-8YY-14P 14 1800 0 3000/3500/4000/5000K 2a 160 <br /> ** Initial Lumen value above are @ 5000K <br /> Installation Guide <br /> WARNING-Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaire electrical systems. Installation should be performed only by a qualified <br /> electrician in accordance with the National Electrical Code and relevant local code. <br /> WARNING-Risk of fire or electric shock.Install this kit only in the luminaires that have the construction features and dimensions shown in the photographs and/or drawings. <br /> WARNING-To prevent wiring damage or abrasion,do not expose wiring to edges of sheet metal or other sharp objects. <br /> WARNING-Risk of fire or electric shock.Luminaire wiring and electrical parts may be damaged when drilling for installation of LED retrofit kit.Check for enclosed wiring and <br /> components. <br /> • Disconnect power at the source before installation,inspection or removal.Do not simply switch off fixture. <br /> • This item is rated at 120-277V.Installer must determine whether line voltage 120-277V is available at the luminaire before installation. <br /> • Not intended for use with emergency exit fixtures or emergency exit lights. <br /> • Not for use with luminaire ballast. <br /> Do not use if product is damaged. <br /> Suitable for use with non-shunted and shunted lamp holders. <br /> • Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation. <br /> • 'This luminaire has been modified to operate LED lamps"shall be mared on the retrofit luminaire where readily visible by the user during normal maintenance including re- <br /> lamping. <br /> • Risk of fire or electric shock.Do not open or modify.No user serviceable parts inside. <br /> • Installers should not disconnect existing wires from lamp holder terminals to make new connections at lamp holder terminals.Instead installers should cut existing lamp <br /> holder leads away from the lamp holder and make new electrical connections to lamp holder lead wires by employing applicable connectors. <br /> • SUITABLE FOR DAMP LOCATIONS.Suitable for use in wet locations when used in an outdoor-rated fixture.Not for use where directly exposed to the weather or water. <br /> • Complies with Part 15 of FCC.Operation is subject to the following two conditions:(1)This device may not cause harmful interference,and(2)This device must accept any <br /> interference received including interference that may cause undesired operation. <br /> SUITABLE FOR"TYPE IC'OR"TYPE NON-IC"LUMINAIRES. <br /> • No external weight or mechanical force should be applied to tube or components. <br /> • THE RETROFIT ASSEMBLY IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY UL <br /> OR AUTHORITIES HAVING JURISDICTION. <br /> "The below ballast wiring represents typical configuration. <br /> The actual ballast wiring varies according to ballast model.It is not needed to change socket if in good condition)to operate double ended lamps, <br /> regardless the type of sockets.Please make sure no side of fixture is connected to Live(L)and the other side to Neutral(N). <br /> Wiring Instruction <br /> Fr 1 <br /> Instant Start <br /> L L <br /> Electronic N <br /> N Ballast <br /> Fl..—.nl lamp I LEO lamp <br /> Program Start or Rapid Start <br /> L L <br /> Electronic N <br /> N Ballast <br /> L <br /> Fluorescent lamp LED lamp <br /> 2 <br />