9916 18TH AVE W E 2025-06-26 - Laserfiche WebLink

Permit #: House address or lot number: Benton Square (Nolan) Unit C- Benton Square Bldg B Unit 12 Walls Type of insulation: Fiberglass Manufacturer: O.C. R-Value: 21 Floor Type of insulation: Fiberglass Manufacturer: Q.C. R-Value: N/A Flat Ceiling/ Attic Type of insulation: Fiberglass Manufacturer: O.C. R-Value: 49 Single Rafter Joist Vaulted Ceiling Type of insulation: Manufacturer: R-Value: Insulation Installer: Blown or Sprayed Fiberglass or Cellulose — Walls R-Value per Inch: Coverage Area: Bag Count: Blown or Sprayed Fibe`Ad:ass nr Cellulose — Ceiling R-Value per Inch: Coverage Area: Bag Count: Sprayed Polyurethane Foam (SPF) Density: Installed Thickness: R-Value of Installed Thickness: Building Component Installed: walls floor ceiling '- ' j - c Company Name: Eco Therm Insulation Installer: ;:b 01 `i (Aj ct Installer Signature: Date: _ Phone Number: 425.233.9931 Washington State Energy Code Reference R303.1 Identification. Materials, systems and equipment shall be identified in a manner that will allow a determination of compliance with the applicable provisions of this code. 303.1.1 Building thermal envelope insulation. An R value identification mark shall be applied by the manufacturer to each piece of building thermal envelope insulation 12 inches (305 mm) or greater width. Alternately, the insulation installers shall provide a certification listing the type, manufacturer and R-value of insulation installed in each element of the building thermal envelope. For blown or sprayed insulation (fiberglass and cellulose), the initial installed thickness, settled thickness, settled R-value, insulation density, coverage area and number of bags installed shall be listed on the certification. For sprayed polyurethane foam (SPF) insulation, the installed thickness of the areas covered and R-Value of installed thickness shall be listed on the certification. The insulation installer shall sigh, date and post certification in a conspicuous location on the job site.