Laserfiche WebLink
1.0 PURPOSE <br /> The purpose of these inspections and tests is to provide assurance that custom <br /> or non-certified equipment meets the requirements of the appropriate codes, <br /> safety orders and industry standards. These inspections and tests are normally <br /> required by the local building inspection authority having jurisdiction (AHJ) when <br /> equipment has not been certified by a Nationally Recognized Testing Laboratory <br /> (NRTL) or other recognized testing agency. These inspections address only the <br /> electrical systems on the equipment listed in Section 5.0 of this report. <br /> 2.0 SUMMARY <br /> This project was initiated at the request of Mr. Justin Fletcher with <br /> ELECTROIMPACT INC. Inspection and testing of the equipment referenced in <br /> Section 5.0 was performed at the Boeing 40-58 Building in Everett, WA by eti <br /> Conformity Services Compliance Engineer Donald Preiss on May 5t", 2023 and <br /> May 12t", 2023. <br /> The electrical discrepancies observed during the inspection and testing of the <br /> equipment are listed in section 7 of this report. Field measurements were taken <br /> by eti Conformity Services as detailed in Section 8. These measurements were <br /> determined to be within the manufacturer's and standard's specifications. eti <br /> Conformity Services considers this equipment to be in compliance with the <br /> electrical codes and standards listed in Section 4.0, pursuant to the conditions of <br /> acceptance described in Section 3.0. An eti Conformity Services evaluation label <br /> has been affixed to the equipment. Note that final approval is under the <br /> jurisdiction of the City of Everett. <br /> Electroimpact has been verified as a Non Vertiv Company. <br /> 3.0 GENERAL CONDITIONS OF ACCEPTANCE <br /> In the event of modifications resulting in a change in the materials, manufacturing <br /> methods, loading, or environment that would affect the use of the accepted <br /> equipment under the provisions of the noted electrical standards, this acceptance <br /> will be considered automatically canceled. The applicant will be required to <br /> request re-examination of this equipment to determine acceptability of the <br /> modifications. <br /> By acceptance of the equipment referenced in Section 5.0, eti Conformity <br /> Services does not assume or discharge the responsibility of the equipment <br /> manufacturer, installer, or other relevant parties. Equipment evaluation is based <br /> upon adherence to sound engineering practices, and upon compliance with the <br /> specific sections quoted from the electrical standards referenced in Section 4.0 of <br /> this report. <br /> Reference No.: 1107995 Page 1 <br />