2730 W MARINE VIEW DR 2019 Plans 2025-06-27 (2)

into place. Once the wall is built to two blocks high,stop the block stacking process and begin backfilling the wall. Make sure drainpipe,filter fabric,and drain mats(if required)are installed before backfilling. Flip the geogrid forward over the face of the wall to get it out of the way and fill the wall with the specified backfill material, so that the material is level with the top of the first course of block. Compact backfill material to specified compaction. Precast concrete "Stone Terra' system. Number of • . , courses varies to suit wall height. _ ✓ >E `1 r.4«, 2'-0" LEVELLING PAD Flip the geogrid back over the wall so that it covers the compacted backfill material. The geogrid should lay level over the compacted backfill (not at any discernable angle). Pull the grid taut and stake it to hold it in place as you begin to backfill over it. Fill to the top of the second course of blocks,compacting as necessary. When finished,you will have two courses of block with a layer of grid between,a 4'high wall, and you will be ready for the next layer of grid.. Continue building in 4' lifts, alternating grid and block,until maximum wall height is reached. NOTE:you will now being laying down two layers of grid for every two layers of block. UPI GEOGRID '.6 -GEOGRID Precast concrete "Stone -roYCYI�' 3r . Terra" system, Number al courses varies to suit wall height. 2'—O" LEVELLING PAD NOTE: Take care to align the grid properly to the wall so that the strength direction of the grid is perpendicular to the wall face. Generally,the grid will be rolled back from the blocks(behind the face of the wall)and cut to the proper reinforcement length. In other words,grid cannot be rolled along the length of the wall,parallel to the wall face. Check with your grid manufacturer if you are unsure about proper grid installation.