Laserfiche WebLink
VE RS IWE LDO Certified <br /> Fabricated <br /> TPO T-JOINT COVERS Accessory <br /> Installation <br /> 1. If membrane has been exposed to the weather, <br /> clean splice intersection area with Weathered <br /> Membrane Cleaner. <br /> 2. Use a lower temperature setting on the hand heat <br /> welder than is used when welding reinforced TPO <br /> membrane.(Typically a setting of 6 on a scale of 10 is <br /> appropriate for welding TPO T-Joint Covers.) <br /> 3. Center the T-Joint Cover over the splice intersection, <br /> begin welding at the center point and work towards <br /> the outside.Use the edge of the roller to crease the <br /> Overview T-Joint Cover into membrane step-offs to achieve <br /> a proper seal. <br /> 4. Using a probe,check all splices for voids and cold <br /> Let Verslco simplify your next VerslWeld TPO installation with welds only once the T-Joint Cover has completely <br /> pre-punched T-Joint Covers.VersiWeld TPO T-Joint Covers cooled.Make any needed repairs. <br /> are used to seal step-offs at splice intersections.Installation <br /> is mandatory on all 60-and 80-mil TPO systems and on REVIEW CURRENT VERSICO SPECIFICATIONS AND DETAILS <br /> 45-mll systems where step-offs have not been properly FOR SPECIFIC INSTALLATION REQUIREMENTS. <br /> sealed.VersiWeld TPO T-Joint Covers consist of 60-mll non- <br /> reinforced flashing punched into a perfect 4.5'-diameter precautions <br /> circle and packaged 100 parts per carton.Available In <br /> white,tan and gray. <br /> Verslco`s VerslWeld TPO T-Joint Covers are part of the 1. The TPO T-Joint Cover is not intended to overlay <br /> Certified Fabricated Accessory(CFA)Program.Certified fasteners and plates as this requires the use of <br /> Fabricated Accessories are the only factory-fabricated reinforced membrane. <br /> accessories that meet the stringent quality tolerances 2. Store T-Joint Covers in a cool,shaded area and <br /> required to be included in a Versico warranted cover with light-colored,breathable,waterproof <br /> roofing system. tarpaulins. I-Joint Covers that have been exposed <br /> to the weather must be prepared with Weathered <br /> Features and Benefits Membrane Cleaner before hot-air welding. <br /> Every T-Joint cover Is a perfect 4.5'-diameter circle TYPICAL PROPERTIES AND CHARACTERISTICS <br /> More consistent appearance than hand-cut flashing <br /> Provides substantial labor savings compared to field- size 4.5"(114 mm) <br /> cut flashing Thickness 0.060"(1.5 mm) <br /> Seals channels at splice intersections created by Packaging 100 per box <br /> seam step-offs Weight(per box) 3.5 lbs.(1.6 kg) <br /> Material Non-Reinforced TPO <br /> Color White,Gray,Tan <br /> Typical properties and chamcteristics are based on samples tested and are not guaranteed for all <br /> samples of this product This data and information is intended as a guide and does not reflect the <br /> specification or specification range for any particular property of this product <br /> VERSICO A SINGLE SOURCE FOR SINGLE-PLY ROOFING <br /> ROOFING SYSTEMS Verslco, PO Rox 1289. Carlisle. PA 17013 <br /> Tel. 800.992.7663 Fox. 7170604036 web. www.versico.com <br />