16 76TH ST SW 2025-08-20 - Laserfiche WebLink

Leaking or corroded sprinklers must be replaced. Automatic Sprinklers must be kept in a cool and dry place. Automatic sprinklers must never be physically altered, such as painted, plated, or coated, once shipped from the factory. If the sprinklers have been in any way modified,they must be replaced. Great caution must be applied to prevent damage to the sprinklers at all stages-before,during,and after installation. Damaged units because of dropping, hitting,over-tightening,or wrench slippage, must be replaced. The Model RC-RES must only be replaced with pendent sprinklers which are listed for residential fire protection service and which have the same nominal K-Factor,the same coverage area,and the same or lower flow ratings(as indicated under Table A "Hydraulic Design Criteria"). When remodeling,such as by adding false beams or light fixtures or changing the location of compartment walls,first verify that the new construction will not violate the installation requirements of the applicable standards of NFPA.Alter the new construction and/or the sprinkler system to suit the requirements of this document and the applicable NFPA regulations. The owner is responsible for the maintenance of the sprinkler system, including inspection and testing of its compliance with this document, as well as the standards of the National Fire Protection Association (e.g., NFPA 25), and the regulations of any other authorities having jurisdiction. The owner should direct any questions regarding the above rules and regulations to the installing contractors or the sprinkler manufacturer. It is recommended that automatic sprinkler systems be inspected, tested, and maintained by a qualified Inspection Service in accordance with NFPA 25. LIMITED WARRANTY For details of warranty, refer to Sales Contract. ORDER PROCEDURE When placing an order, please contact a local distributor with the following information (Model Name, Temperature Rating and Finish). Sprinkler • Model: RC-RES SIN: SS8464, Residential Flat Concealed Sprinkler, Pendent, K4.9, Temperature: 1620F(72°C) or 205°F (96°C) Cover Plate Assembly • 2-5/8 inch (�68mm) or 3-1/4 inch (�83mm) or 2-5/8 inch square(❑68mm), Order separately from Sprinkler Please refer to the chart below for available sizes, temperature, and finishes. Standard Finishes Custom I Finishes White Ivory Beige Brown Black Nickel Copper Wood Custom Custom Grain Color Pattern 2-5/8" Round, 140°F O O - - - - - - O O 3-1/4" Round, 140°F O O O O O O O O O O 2-5/8"Square, 140°F O - - 2-5/8" Round, 162°F O - - 3-1/4" Round, 162°F O O O O O 2-5/8" Square, 162°F O - - - - Tools & Accessories • Socket NR-H • Cap Removal Tool for RC for use with a 3/8" drive ratchet (not included) • Cover Plate Installation Tool • Socket NR-H Plastic for use with a 1/2" drive ratchet (not included) Iwww.senjusprinkler.com Page 8 of 8 Document No.U085168• 02-08-2021