11109 16TH AVE SE 2025-08-20 - Laserfiche WebLink

GHLF 24 VDC Series Low Frequency Audible Signal Gentex Super-Slide' Mounting Bracket Architect & Engineering Specifications Allows the installer to prewire the system,test for system The alarm horns shall be Gentex model GHLF.The appliance shall supervision,remove the signal head until occupancy,switch out be listed with Underwriters Laboratories(ANSI/UL)for use with fire Gentex signals without changing mounting brackets and has protective signaling systems ANSI/UL 464 and with CAN/ULC 5525 locking edge connector for snap-in-place installation. with intended use in fire alarm systems.The GHLF will produce a peak sound output of 88.3 dBA as measured in an anechoic Gentex Checkmate' Instant Voltage chamber.The appliance shall be polarized to allow for electrical supervision of the system wiring.The unit shall be provided with Verification a mounting bracket with terminals and barriers for input/output It is often necessary to confirm the voltage drop along a line of wiring and be able to mount to a single gang or double gang box or devices.The access holes are provided in the back of the terminal double workbox without the use of an adapter plate.The GHLF shall block to allow the voltage to be measured directly without be mounted on the wall or the ceiling.The unit shall have an input removing the device.Typically this would be done at the end of the voltage range of 16-33 volts with either direct current or full wave line to confirm design criteria.Most measurements will be taken rectified power at 24 VDC.The appliance shall be capable of testing using the S+and S-locations although access is provided to other supervision without disconnecting wires,verify voltage without locations.Notice:Care should be taken to notshort the test probes. removing unit and be capable of mounting to a surface back box. ProductsGENTEX Fire Protection 0• .. CORPORATION :00