Laserfiche WebLink
6.0" <br /> 15.24 cm <br /> 1524cm 66cm <br /> Gentex Super-Slide' Mounting Bracket <br /> UL Listed <br /> Allows the installer to prewire the system,test for system Control Signal Signal <br /> supervision,remove the signal head until occupancy,switch out Panel S+ S+ S- H+ H- S+ S+ S_ H+ H- <br /> Gentex signals without changing mounting brackets and has Supervised 0 0 B e <br /> locking edge connector for snap-in-place installation. Signal Circuit <br /> END OF LINE <br /> RESISTOR <br /> Gentex Checkmate' Instant Voltage <br /> Verification <br /> It is often necessary to confirm the voltage drop along a line of <br /> devices.The access holes are provided in the back of the terminal DDOO NOT PAW <br /> block to allow the voltage to be measured directly without o <br /> 0 <br /> removing the device.Typically this would be done at the end of the o o <br /> line to confirm design criteria.Most measurements will be taken 0 � O <br /> using the S+and S-locations although access is provided to other <br /> locations.Notice:Care should betaken to not short the test probes. jo <br /> Notes + <br /> • Operating temperature:320 to 120OF(0'to 49°C) O <br /> H+ <br /> • The GCS/GCC Series is not listed for outdoor use H- <br /> • For nominal and peak current across ANSI/UL regulated voltage s <br /> T <br /> range for filtered DC power and unfiltered(FWR[Full Wave <br /> Rectified])power,see installation manual O 0 <br /> • The sound output for the temporal 3 tone is rated lower since <br /> o ° o <br /> the time the horn is off is averaged into the sound output rating. � o o <br /> While the horn is producing a tone in the temporal 3 mode,its <br /> sound pressure is the same as the continuous mode. <br /> • This appliance is not recommended for use on coded or pulsing <br /> signaling circuits <br />