Laserfiche WebLink
Model W2(upright, pendent) <br /> lww�= <br /> Model W13(Legacy frame with guard installed) <br /> Model W4 <br /> Model W14(New frame with guard installed) (recessed,concealed pendent) <br /> Finishes') <br /> Standard Finishes Special Application Finishes <br /> Sprinkler F1,F2 and FPM CCP Cover Sprinkler F1, F2 and FP(2) CCP Cover Plate(2) <br /> Escutcheons Plate(2) Escutcheons <br /> Bronze Brass Chrome Electroless Nickel PTFE(3)(4) Bright Brass Bright Brass <br /> Chrome Chrome White Paint Bright Brass(-') Satin Chrome Satin Chrome <br /> White Polyester(3) White Polyester Satin Chrome Custom Color Polyester Custom Color Paint <br /> Custom Color Polyester(3) <br /> Notes: <br /> 1. Paint or any other coating applied over the factory finish will void all approvals and warranties. <br /> 2. Model FP escutcheons and Model CCP sprinklers utilize a galvanized steel cup with a finished trim ring or cover plate. <br /> 3. cULus Listed as corrosion resistant. <br /> 4. FM Approved as corrosion resistant. <br /> 5. For 200T(93°C)maximum temperature rated sprinklers only. <br /> Installation Maintenance <br /> Model F1 FR Series sprinklers must be installed in accordance with Reliable Model F1 FR series sprinklers should be inspected and <br /> NFPA13 and the requirements of all applicable authorities having the sprinkler system maintained in accordance with NFPA 25, as <br /> jurisdiction. Model F1 FR Series sprinklers must be installed with well as the requirements of any Authorities Having Jurisdiction. <br /> the Reliable sprinkler installation wrench identified in this Bulletin. Prior to installation, sprinklers should remain in the original <br /> Any other wrench may damage the sprinkler. The Models W2 and cartons and packaging until used.This will minimize the potential <br /> W4 wrenches have two sets of jaws. Use the smallest set of jaws for damage to sprinklers that could cause improper operation or <br /> that fit on the wrench flats of the sprinkler. A leak tight sprinkler non-operation. <br /> joint can be obtained with a torque of 8 to 18 lb-ft(11 to 24 <br /> N•m). Do not tighten sprinklers over the maximum recommended Do not clean sprinklers with soap and water, ammonia liquid or <br /> installation torque. Exceeding the maximum recommended any other cleaning fluids. Remove dust by gentle vacuuming <br /> installation torque may cause leakage or impairment of the without touching the sprinkler. <br /> sprinkler. Replace any sprinkler which has been painted (other than factory <br /> applied).A stock of spare sprinklers should be maintained to <br /> Glass bulb sprinklers have orange bulb protectors or protective allow quick replacement of damaged or operated sprinklers. <br /> caps to minimize bulb damage during shipping, handling and Failure to properly maintain sprinklers may result in inadvertent <br /> installation. Reliable sprinkler installation wrenches are designed operation or non-operation during a fire event. <br /> to install sprinklers with bulb protectors in place. Remove the bulb <br /> protector at the time when the sprinkler system is placed in service <br /> for fire protection. Removal of the bulb protector before this time <br /> may leave the bulb vulnerable to damage. Remove bulb protectors <br /> by undoing the clasp by hand. Do not use tools to remove bulb <br /> protectors. <br /> Bulletin 074 Reliable Page 8 of 9 <br /> January 2024 www.reliablesprinkler.com <br />