Laserfiche WebLink
City of Everett Permit Services <br /> EVERETT Reviewed for Permit 01/30/2025 <br /> B. Minimum Fireplace Opening • The metal floor of the solid fuel firebox may be removed <br /> to facilitate the installation of the insert. <br /> Minimum fireplace opening requirements for a standard 3/4 <br /> inch deep surround are shown in Figure 3.8. For smaller • Cutting of any sheet metal parts of the fireplace in which <br /> openings, a custom surround is available. the gas fireplace insert is to be installed is prohibited, <br /> except the floor as tested for and as noted above. <br /> WARNING! Risk of Fire or Burns! Provide adequate <br /> clearance around air openings and for service access. A minimum 1/4 inch gap from the bottom of the appliance <br /> Due to high temperatures, the appliance should be locat- to the metal floor of the solid fuel firebox is REQUIRED. <br /> ed out of traffic and away from furniture and draperies. See side view in Figure 3.6. <br /> • Manufactured gas inserts can be installed as a zero <br /> For Installation into a Zero Clearance Wood burning fire- clearance appliance. See Section 3C for clearance <br /> place: detail. <br /> • The brick (refractory), glass doors, screen rails, screen <br /> mesh and log grates can be removed from a factory <br /> built firebox in order to gain minimum gas insert opening <br /> requirements. <br /> • Any smoke shelves,shields and baffles may be removed <br /> from the factory built firebox if attached with mechanical <br /> fasteners. <br /> SIDE VIEW <br /> 112 in. <br /> Figure 3.7 Minimum Required 1/2 in.Gap <br /> NOTICE: 112 inch gap must be maintained or components <br /> will overheat. <br /> O <br /> MINIMUM 1/4 IN.REQUIRED <br /> COMBUSTIBLE FLOOR UNDERNEATH APPLIANCE <br /> Figure 3.6 Solid Fuel Floor Clearance <br /> • The appliance may not be placed directly on the base of <br /> the outer wrap, a 1/4 inch airspace MUST be provided <br /> between the insert and the floor of the outer wrap. Use <br /> the leveling legs to raise the insert a minimum of 1/4 inch. <br /> The original fireplace may never be returned to solid <br /> fuel in this condition. The sidewalls and top structure <br /> of the firebox may not be altered with the exception of <br /> removable baffles and dampers. <br /> Heat&Glo • SUPREME-125-IFT,SUPREME-130-IFT,SUPREME-135-IFT Installation Manual 2532-980 Rev. F 5/19 13 <br />