11311 19TH AVE SE CLUBHOUSE 2025 Plans 2025-09-16

City of Everett Permit Services EVERETT Reviewed for Permit 01/30/2025 4 Installation Preparation Prepare the existing solid fuel masonry or factory built D. Fireplace Conversion Notice non-combustible firebox for installation. The fireplace conversion notice is included in the appliance A. Cleaning manual bag. Permanently attach the label with the follow- ing warning to the inside lower back of the fireplace firebox Prior to installing the gas insert: into which the insert is being installed.Silicone or mechani- • Ensure that the woodburning fireplace cavity is clean cal fasteners may be required to properly secure the label. and free of ash, soot, and other debris. WARNING! Risk of Fire! This fireplace has been con- B. Flue Damper verted for use with a gas fireplace insert only and cannot be used for burning wood or solid fuels unless all original Fully lock the solid fuel fireplace's flue damper in the open parts have been replaced, and the fireplace re-approved position, OR completely remove it. by the authority having jurisdiction. C. Gas Line E. Electrical Outlet Box Note: If the factory built fireplace has no gas access hole An outlet box may be installed in a bottom back corner of provided, an access hole of 1 inch (25 mm) diameter or the existing solid fuel masonry or factory built fireplace less may be drilled through the lower sides or bottom of the to power the appliance. Each unit ships standard with a firebox in a proper workmanship-like manner.This access cord assembly to permit blowers or other optional acces- hole must be plugged with non-combustible insulation after sories to be used. The accessories plug into the new out- the gas supply line has been installed. let box or may be routed out onto the hearth to a nearby • Install gas line to the factory provided flex line. See outlet. Figure 4.1. • Check local codes and gas line sizing requirements following NFPA54. See Section 7. NOTICE: DO NOT wire 110-120 VAC to wall switch. • It is recommended that extra length of gas line be installed within the existing wood burner or masonry fireplace to allow removal of the insert for future servicing RECOMMENDED needs. ELECTRICAL OUTLET LOCATIONS Z O rr LIANCE i t fi M. a rt �r� :ja rIf1:: I Figure 4.2 Electrical Outlet Detail I�r1( �!lJl�l�aAtEI!: Appliance Cord Length (approximate) 6j!i'l�i s Appliance Size Left Side Right Side 25 in. 10 ft. 6 in. 8 ft. 30 in. 10 ft. 3 in. 7 ft. 6 in. Figure 4.1 35 in. 10 ft. 7 ft. 20 Heat&Glo SUPREME-125-IFT,SUPREME-130-IFT,SUPREME-135-IFT Installation Manual • 2532-980 Rev. F • 5/19