Laserfiche WebLink
City of Everett Permit Services <br /> EVERETT Reviewed for Permit 01/30/2025 <br /> Wpf .Gf.. <br /> C. Venting Components To prevent odors and cold air drafts,it may be necessary to <br /> CAUTION! Risk of Cuts/Abrasions/Flying Debris. place non-combustible insulation or field fabricated metal <br /> Wear protective gloves and safety glasses during instal- plates around the vent pipe flues as they go through the <br /> lation. Sheet metal edges are sharp. damper. <br /> The vertical vent termination system installed on this model <br /> includes: <br /> Note: The LINK-DV4-30B and LINKSQ-DV4-30 systems <br /> • One length of 3-inch flexible vent pipe for exhaust air REQUIRE this insulation. <br /> (included with vent kit). <br /> • One length of 3-inch flexible vent pipe for combustion <br /> air (included with vent kit). <br /> • One vertical termination cap (included with vent kit). <br /> Masonry Factory Built LINK-DV30B <br /> Wood Burning LINKSQ-DV30 <br /> Installation* <br /> LINK-DV30B LINK-DV4-3013 <br /> LINKSQ-DV30 LINKSQ-DV4-30 <br /> Installation* Installation** <br /> OPTIONAL LINK-ZC-ADPB <br /> FOR USE WITH CLASS A <br /> WOODBURNING PIPE \ <br /> TERMINATION \yIU <br /> CAP Remove 18 inch x 18 inch <br /> flashing on cap by removing <br /> EXHAUST EXHAUST 3 screws. Connect both the <br /> AIR AIR LINK-ZC-ADPB to Class A <br /> Pipe and the termination cap <br /> VENT PIPE VENT PIPE to the LINK-ZC-ADPB with <br /> self tapping screws. <br /> FORS Note: Untwist the <br /> pipe while extend- <br /> Note: Untwist the ing it,to achieve <br /> pipe while extend- WARNING: full 30'length. + <br /> ing it,to achieve DO NOT BLOCK <br /> full 30'length. THIS PIPE END! OR <br /> y LINK-DV4-3013 <br /> LI N KSQ-DV4-30 <br /> Installation** <br /> INLET AIR INLET AIR OPTIONAL LINK-ZC-ADPB <br /> VENT PIPE VENT PIPE FOR USE WITH CLASS A <br /> WOODBURNING PIPE <br /> 'LINK-DV30B/LINKSQ-DV30:This installation may perform better and allow less cold air infiltration in <br /> negative pressure settings. <br /> "LINK-DV430B/LI N KSQ-DV4-30: <br /> • This installation may be more susceptible to cold air infiltration and the effects of negative pressure <br /> on the appliance's performance. <br /> •Depending on the chimney cleanliness, consider using the full length intake so as to lessen <br /> the possibility of sense rod contamination and flame rectification issues. <br /> Figure 5.4 <br /> Heat&Glo • SUPREME-125-IFT,SUPREME-130-IFT,SUPREME-135-IFT Installation Manual • 2532-980 Rev. F 5/19 23 <br />