1001 N BROADWAY EVCC 2025-10-03 - Laserfiche WebLink

I BMP C103: High Visibility Fence Purpose Fencing is intended to: I 1. Restrict clearingto approved limits.pp 2. Prevent disturbance of sensitive areas, their buffers,and other areas required to be left undisturbed. f , ; 3. Limit construction traffic to designated construction entrances, exits, or internal roads. 4. Protect areas where marking with survey tape may not provide adequate protection. Conditions of Use To establish clearing limits plastic, fabric, or metal fence may be used: E F At the boundary of sensitive areas,their buffers, and other areas fi required to be left uncleared. I • As necessary to control vehicle access to and on the site. t Design and High visibility plastic fence shall be composed of a high-density Installation polyethylene material and shall be at least four feet in height. Posts for l ; Specifications the fencing shall be steel or wood and placed every 6 feet on center (maximum) or as needed to ensure rigidity. The fencing shall be fastened I to the post every six inches with a polyethylene tie. On long continuous lengths of fencing,a tension wire or rope shall be used as a top stringer to prevent sagging between posts. The fence color shall be high visibility orange. The fence tensile strength shall be 360 lbs./ft. using the ASTM D4595 testing method. If appropriate install fabric silt fence in accordance with BMP C233 to act as high visibility fence. Silt fence shall be at least 3 feet high and must be highly visible to meet the requirements of this BMP. j Metal fences shall be designed and installed according to the ( manufacturer's specifications. Metal fences shall be at least 3 feet high and must be highly visible. Fences shall not be wired or stapled to trees. ` Maintenance If the fence has been damaged or visibility reduced, it shall be repaired or Standards replaced immediately and visibility restored. I r � i Vohnnne I1--Consln•uction Sto1•nnvctter Pollution Prevention-August 2012 4-6