2623 GRAND AVE 2023 Plans 2025-09-30

�MyBuildingPermit.com `/MyBui[di ngPermft.cGom Construction Ti Sheet 19 a service of eCityGov.net Construction Tip Sheet 19 p Safety Glazing 3. Glazing in Windows:Safety glazing in windows is required if the individual panel meets all of This Tip Sheet reflects code requirements of the 2018 International Residential Code(IRC)with the following requirements(R308.4.3): Washington State Amendments. a. Exposed area of the individual panel is greater than 9 square feet. b. The bottom edge of the glazing is less than 18 inches from the floor. What is Safety Glazing? c. The top edge of the glazing is more than 36 inches above the floor. Safety glazing is glass that is less dangerous when it breaks,such as tempered or laminated d. There is a walking surface within 36 inches,measured horizontally,from the glazing. glass. Exceptions: i. Decorative glazing. Per R308.1,where safety glazing is required,each pane must be provided with a manufacturer's making contact with the glass s ii. Where a horizontal rail capable of resis installed on the accessible side the sting 50 pounds per linear foot of force label defining the type of glass and safety glazing standard to which it complies.For tempered glazing the label must be permanently etched,fired,or embossed,on the glass or be a type that glazing 34 without maki ki 38 inches above the walking surface. once applied cannot be removed without being destroyed.For other types of safety glazing,a 4. Glazing in Railings and Guards:All glazing in railings and guards,including structural certificate,affidavit or other evidence confirming compliance with the code shall be provided at baluster panels and nonstructural in-fill panels,is required to be safety glazing.(R308.4.4) time of inspection. 5. Glazing and Wet Surfaces:Glazing in walls,enclosures,or fences around showers,bathtubs, Required Safety Glazing in Hazardous Locations pools,hot tubs,spas,saunas,and steam rooms where the bottom edge of the glazing is less 1. Glazing in Doors:Safety glazing is required in fixed and operable panels of swinging,sliding, than 60 inches from the standing or walking surface is required to be safety glazing.Safety and bifold doors.Safety glazing is not required in a door if the glazed openings do not allow the glazing is not required where the glazing is more than 60 inches,horizontally,from the edge of passage of a 3-inch sphere,or if the glazing in the door is decorative.(R308.4.1) the water.(R308.4.5) 2. Glazing Adjacent to Doors:Glazing adjacent to doors is required in the following locations if Safely,glazing the bottom edge of the glazing is less than 60 inches above the walking surface:Within 24 not required inches of either side of the door in the plane of the door in a closed position,or if glazing is in a wall less than 180 degrees from the lane of the door in a closed position and within 24 inches lazln Safety glazing 9 P P not re aired g required of the hinge side of an in-swinging door.Safety glazing is not required if there is an intervening q /wall or permanent barrier between the door and the glazing.(R308.4.2) / Safety glazing required L Walking surface Safety glazingnotrequired ————(Interveningwall) required Safety glazJng CSafety glazing " not required 6cr \ �60• Soot or P i,_24•� �_24•_ Safety glazing 6. Glazing Adjacent to Bottom Stair Landings:Glazing adjacent to the landing at the bottom of required a stairway where the glazing is less than 36 inches above the landing and within a 60-inch horizontal are from the bottom tread must be safety glazing.(R308.4.7) 24• 24- Safety glazing Safety glazing not required not required January 24,2021 MyBuildingPermltcom I Safety Glazing 1 January 24,2021 MyBuildingPennitcom I Safety Glazing 2 eCityGov.net eCityGov.net 2M-ewrc u,� xas...eajGc A+