35 SE EVERETT MALL WAY 2025 DIZAYUS AFRICAN MARKET 2025-11-03

i Permit Inspections V E R E T T City of Everett WASHINGTON Permit Number: P2203-014 Description: PLUMBING FOR 3-COMPARTMENT SINK, Applied:3/8/2022 Approved: 6/28/2022 Site Address: 35 SE EVERETT MALL WAY#103 Issued:7/1/2022 Finaled: 7/20/2022 City,State Zip Code: EVERETT,WA 98208 Status: FINALED Applicant:YUSUPHA BOJANG Parent Permit: B2203-022 Owner:TOP HILL PLAZA LLC Parent Project: Contractor:TENANT W/LETTER Details: MPO SINK,AND HAND SINK PLUMBING FOR 3-COMPARTMENT SINK, SCHEDULED DATE COMPLETED DATE TYPE INSPECTOR RESULT REMARKS 7/5/2022 7/5/2022 PLUMB 031--ROUGH BILLY APPLETON NOT READY Notes: Contact Name:YUSUPHA BOJANG Site Address:35 SE EVERETT MALL WAY#103 Phone:2064125532 e-Mail:YUSUBOJANGI@GMAIL.COM (7/5/2022 9:13 AM BGA) bga changed Inspection Type from PLUMB 08-FINAL to PLUMB 03-ROUGH IN (7/5/2022 9:19 AM BGA) 1.Owner must expose all water piping and waste and vent piping inside walls for inspection before calling for final.All plumbing fixtures and grease trap must be installed per UPC code after rough in inspection has been approved,and then called in for separate final inspection. 7/13/2022 7/13/2022 PLUMB 03-ROUGH JASON CORRECTION IN MORRISSEY REQUIRED Notes: Contact Name:YUSUPHA BOJANG Site Address:35 SE EVERETT MALL WAY#103 Phone:2064125532 e-Mail:YUSUBOJANGI@GMAIL.COM (7/13/2022 11:02 AM JJM) Remove downstream p trap as fixtures cannot be double trapped.Per UPC Rotate HGI 180 degrees so internal flow control is on the inlet. Center trap under three compartment meant sink per UPC with indirect hub drain per UPC code and health department requirements. Replace 2"medium turn 90 with long turn 90 per UPC chapter 7. Add 11/2"studor vent on trap arm before grease interceptor. *** Make sure HGI is installed per manufacturers instructions for proper function. *** Make sure system drains properly before inspection. I Printed: Monday, 13 October,2025 1 of 2 rk SUPERION