4510 S 4TH AVE 2025-11-06 - Laserfiche WebLink

Drew Martin From: Drew Martin Sent: Thursday,June 30, 2022 12:22 PM To: leo.jacobs@frontier.com Subject: City of Everett Permit Services:4510 S 4th Street (B2205--075) - First Building Intake Review Attachments: 2018 IRC-Typical Code References_04-12-2021.docx; CoE_Residential Drawing Pre pa ration_Edited 09-27-2021.pdf Hello, Leo. Your application has been received and a permit set up. However, the submitted documents are not sufficiently developed for us to perform a comprehensive review at this time. Information is attached to provide guidance. Construction-level documents should be submitted for review. Two complete sets of the revised drawings should be submitted to replace the previously submitted drawing sets. Preliminary comments are provided below to assist in preparing the drawings, but these are not intended to provide a comprehensive review. The resubmittal documents should include an itemized response letter clarifying how the review comments below have been addressed. Depending on your experience with the adopted codes and preparing documents, we recommend consulting with a design professional to assist you. Intake Review Comments: General: 1. The submitted documents include sketches for the proposed project. Construction-level drawings prepared using established drafting standards are required to substantiate compliance with the IRC. The drawings should include plans, building sections, details, material specifications, design loads, architectural and structural notes, etc. as needed to clearly show the proposed work. The current editions of the building codes applicable to the project should be specified. See IRC Section R106.1.1. 2. The house is subject to Code Enforcement action per File No. CE20-0904 & CE21-0349. The drawings to not provide sufficient information to address the unpermitted conditions and should be revised. Issues identified include but are not limited to unpermitted and unsafe interior and exterior staircases, conversion of the attic to habitable space without permits, and modifications to the main level including but not limited to replacement of GWB. The electrical and mechanical systems have also been updated. See IRC Section R105.1 and R113.2. 3. The proposed scope-of-work is not clear. The drawings should clearly delineate between existing and new work using established drafting standards. Construction that is not original or performed under a previously issued and finaled building permit does not qualify as existing and must be shown as new work. All demolition should be shown on the existing floor plans. All new construction should be shown on the new floor plan. Where the proposed project includes modifications existing building components (e.g., gypsum wall board, insulation, etc.), these components should be similarly delineated from existing component that are not being altered. See IRC Section R106.1.1. 1