Laserfiche WebLink
CS-24 & C H S-24 <br /> POTTERIndoor Wall Mount Colored Lens <br /> The Symbol of Protection Strobe and Horn/Strobe Series <br /> Wiring Diagrams <br /> UL Listed <br /> UL Listed Control <br /> Control Panel Signal Signal <br /> Signal Signal S+ S+ S- H+ H- S+ S+ S H+ H- <br /> Panel <br /> S+ S+ S- H+ H- S+ S. S- H+ H_ Supervised <br /> Supervised If& 0 0 0 0 Signal Circuit <br /> Signal Circuit \ + <br /> \ + L END LINE <br /> END OF LINE RESISTOR <br /> RESISTOR <br /> \ + <br /> END OF LINE <br /> RESISTOR <br /> NOTES. <br /> • All strobes are designed to flash as specified with continuous applied voltage. Strobes should not be used on coded or pulsing signaling circuits. <br /> However,use of the AVSM control module or Gentex synchronization protocol is permitted to synchronize the strobe,horn and/or mute the horn. <br /> • FOR SYNCHRONIZATION WIRING INFORMATION,REFERENCE AVSM CONTROL MODULE DATA SHEET(8830050)AND/OR <br /> AVSM CONTROL MODULE MANUAL FOR SYNCHRONIZATION MODULE WIRING DIAGRAMS.AVSM CONTROL MODULE <br /> DATA SHEET AND MANUAL CAN BE OBTAINED AT http://pottersignal.com OR CALL POTTER ELECTRIC AT 1-800-325-3936. <br /> Architect and Engineering Specifications <br /> The audible and/or visible signal shall be Potter Colored Lens Series or approved equal and shall be listed by Underwriters Laboratories Inc.per ANSFUL <br /> 1638 and ANSI/UL 464 and shall have compliance with the polar dispersion requirements of ANSFUL 1971.The notification appliance shall also be listed <br /> with the California State Fire Marshal(CSFM). <br /> The notification appliance(combination audible/visible)shall produce a peak sound output of 100dBA or greater as measured in an anechoic chamber.The <br /> signaling appliance shall also have the capability to silence the audible signal while leaving the visible signal energized with the use of a single pair ofpower <br /> wires.Additionally,the user shall be able to select either continuous or temporal tone output with the temporal signal having the ability to be synchronized. <br /> Unit shall be capable of being installed so that any unauthorized attempt to change the candela setting will result in a trouble signal at the fire alarm control <br /> panel. <br /> The audible/visible and visible signaling appliance shall also maintain a minimum flash rate of l Hz or up to 2 Hz regardless of power input voltage.The <br /> appliance shall have an operating current of 74mA or less at 24 VDC for the 15Cd strobe circuit. <br /> The appliance shall be polarized to allow for electrical supervision of the system wiring.The unit shall be provided with a mounting bracket with terminals <br /> with barriers for input/output wiring and be able to mount to a single gang or double gang box or double workbox without the use of an adapter plate.The <br /> unit shall have an input voltage range of 16-33 volts with either direct current of full wave rectified power for 24 volt models. <br /> The appliance shall be capable of testing supervision without disconnecting wires.Also,the appliance shall be capable of mounting to a surface back box. <br /> The unit shall also be able to verify voltage at the unit without removing unit. <br /> Potter Electric Signal Company,LLC • St. Louis,MO • Tech Support: 866-956-1211 /Customer Service: 866-572-3005 • www.pottersignal.com <br /> ISO 9001:2008 1 DESIGNING,MANUFACTURING, <br /> 8 DISTRIBUTING QUALITY SYSTEMS 8830055-REV B • 10/14 PAGE 4 OF 4 <br />