Laserfiche WebLink
L BAD <br /> CALIBRATION SERVICES <br /> 12870 Interurban Ave South • Tukwila, WA 98168 <br /> Phone: 206-957-4479 Website: www.gcscal.com <br /> CERTIFICATE OF CALIBRATION #354940 <br /> Issued TO: Calibration Compliant To: <br /> ISO 9001:2015/AS9100 Rev. D <br /> BRANOM INSTRUMENT CO ANSI/NCSL Z540-1 <br /> 5610 4TH AVE S ISO/IEC 17025:2017 <br /> SEATTLE, WA 98108 ISO10012:2003 <br /> Item ID: 78504454 Purchase Order Number: PO-39768 <br /> Item Description: CLAMP ON AMMETER Calibration Date: 12/31/2024 <br /> Item Size: 600 VDC,600 AAC Calibration Due: 12/31/2025 <br /> Manufacturer: FLUKE Temperature(Deg F): 71 <br /> Model Number: 335 Humidity(%): 35 <br /> Serial Number: 78504454 Procedure: 33K1-4-2513-1 <br /> Assigned Department: N/A <br /> Chester Mitre, Technician <br /> Item Location: N/A <br /> Calibration Location: INHOUSE LAB <br /> Instrument 78504454 As Found: In Tolerance <br /> Instrument 78504454 As Left: In Tolerance <br /> Date Certificate Issued: 12/31/2024 <br /> See Page 2 for Calibration Data Sheet. <br /> Global Calibration's Quality System is Accredited to ISO/IEC 17025:2017. <br /> Global Calibration Services'quality management system conforms to ISO 9001:2015,AS9100 Rev. D, ANSIINCSL Z540-1, ISO/IEC 17025:2017, ISO 10012:2003, and the <br /> technical requirements of the customer's order. All calibrations are performed using internationally recognized standards traceable to the SI Units. Traceability is achieved <br /> through the National Institute of Standards and Technology(NIST),other National Measurement Institutes(NMIs),or by using natural physical constraints,Intrinsic standards or <br /> ratio calibration techniques. Unless otherwise indicated,the combined estimated uncertainty of the measurement has a coverage factor of k=2 at a confidence level of 95%and <br /> calibrations are performed at a minimum 4:1 accuracy ratio. Any number of factors may cause the instrument to drift out of specification before the recommended recalibration <br /> date contained in this certificate. The information shown on this certificate applies only to the instrument identified above and may not be reproduced,except in full,without prior <br /> written consent from Global Calibration Services, <br /> Page 1 of 2 <br />