3314 CEDAR ST URENDA AUTO PAINTING 2016-09-20

(b) It shall be unlawful for any person to cause or allow the installation or use of any device or use of any means designed to mask the emission of an air contaminant which causes detriment to health, safety or welfare of any person. SECTION 9.15 FUGITIVE DUST CONTROL MEASURES t�doptcd 03/I3/GS (12) Revised 06/09/43 (�3G). 06/09/88(621), OR/10/59 (644), 03/II/99 (882) (a) It shall be unlawful for any person to cause or allow visible emissions of fugitive dust unless reasonable precautions are employed to minimize the emissions. Reasonable precautions include, but are not limited to, the following: (1) The use of control equipment, enclosures, and wet (or chemical) suppression techniques, as practical, and curtailment during high winds; (2) Surfacing roadways and parking areas with asphalt, concrete, or gravel; (3) Treating temporary, low-traffic areas (e.g., construction sites) with water or chemical stabilizers, reducing vehicle speeds, constructing pavement or rip rap exit aprons, and cleaning vehicle undercarriages before they exit to prevent the track-out of mud or dirt onto paved public roadways; or (4) Covering or wetting truck loads or allowing adequate freeboard to prevent the escape of dust-bearing materials. (b) Compliance with the provisions of this section shall not relieve any person from the responsibility to comply with Section 9.11 of this regulation. SECTION 9.16 SPRAY-COATING OPERATIONS ndop�,do�ii3i�>> ��oo> Rcvised 07/OR/99 (8RG). 07/12/Ol (944). 02/22/07 (1089). 10/28/10 (1200) (a) Applicability. This section applies to indoor and outdoor spray-coating operations when a coating that protects or beautifies a surface is applied with spray-coating equipment, except as exempted in Section 9.16(b) of this regulation. Mobile spray-coating operations for motor vehicles or motor vehicle components are subject to Section 9.16(e) of this regulation. (b) Exemptions. The following activities are exempt from the provisions of Sections 9.16(c), (d), and (e) of this regulation. Persons claiming any of the following exemptions shall have the burden of demonstrating compliance with the claimed exemption. (1) Application of architectural or maintenance coatings to stationary structures (e.g., bridges, water towers, buildings, stationary machinery, or similar structures); (2) Aerospace coating operations subject to 40 CFR Part 63, Subpart GG. This includes all activities and materials listed in 40 CFR 63.741(�; 12/10 9-6 Regulation f