7318 EVERGREEN WAY 2016-09-20 - Laserfiche WebLink

• • Page 2 of 3 1. The dimension of the ramp shown on the drawings from the van access aisle to the tenant entrance should be shown to be not greater than 1:12 slope, per ICC A117�Z009 section 405.2, to provide an accessible route, per ICC A117-2009 section 406.1. a) The ramp length creates 1:6 slope on the drawings submitted on 8/7. 2. The landing at the top of the ramp should be shown as a minimum of 44 inches, per ICC A117-2009 section 406.7, and IBC section 1101.2.2 as amended by the State of Washington. 3. The van accessible parking spot shouid be shown as ciose to the building entry or tenant space(s) as possible, per IBC section 3411.12, There are several tenants in the building, so the location of the accessible route to the tenant door(s) should be clearly marked on the drawings submitted for permit. 4. The van accessible parking sign focation sh��uld be shown on the site plan or building, per IBC section 1110.1 (1) and should not obstruct parking or the sidewalk clear width requirement. Code references cited are the 2012 Internationai Building Code (IBC) and the 2012 International Property Maintenance Code (IPMC): rittas://everettwa.gov/174/Construction- Codes The current IBC referenced standard for accessible design is the 2009 "Accessible and Usabie Buildings and Facilities" (ICC/ANSI A117.1). Federal ADA regulations and standards may be more restrictive. All codes referenced, as adopted by the City of Everett, must include current revisions by the State of Washington. Public Works and Traffic Comments Michael Brick: 425-257-7790, mbrick@everettwa.gov Sabrina Fandler: 425-257-7813, sfandler@everettwa,gov 1. Please resubmit drawings showing the existing conditions on-site, drawn to scale at minimum 1"=10'. Please label all existing conditions/dimensions as "existing" for clarity. All dimensions must be provided including (at a minimum) the following: 2. Width from building face to edge of sidewalk 3. Width from edge of sidewalk/planter to face oi- curb/pavers 4. Width of existing parking stalls, measured from stripe centerline to centerline. 5. Length of existing parking stalis from face of c�arb to edge of paint stripe. 6. Width of existing drive aisle from edge of existing �arking stali paint stripe to existinc� building/obstruction 7. Overall length of existing building frontage (where parking stalls are/can be in front of building) 8. Length and width of existing access ramp in front of the door, including the dimension of the landing from the top of the ramp to the restaurant door 9. Ali proposed changes to restore the existing coriditions to acceptable standards must be ' shown on the plans and must be clearly labeled as'�proposed". The proposed work shali be clearly identifiable (bold line type/weight, different color, etc.) in comparison to the existing conditions. A legend should be added to the plans as needed to distinguish between existing and proposed conditions. 10. Traffic and Public Works will allow the existing wheel stops to be removed if desired, as vehicles can have up to a 2.5' hangover into the landscaped area. This condition will only be allowed and approved if the vehicle hangover cannot physically encroach into CITY OF EVERETT- 3200 Cedar Street- Everett, WA 98201- (4�4)257-8800 -Fax- (425) Z57-8882