7601 EVERGREEN WAY DOLLAR TREE 2016-09-22

• • • • � • � � � • 2012 Washington State Energy Code Compliance Forms for Commercial Buildings including R2 8 R3 over 3 stories and all Rt Revised Jan 2014 Project Address DOLLAR TREE (DEAL #8641) Date 4/20/2015 The following iniurtnation is necessary to check a permit application for compliance with the lighting, motor, and transfortner requirements in the Washington State Energy Code, Commercial Provisions. Applicability Location in Buiiding Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes LIGHTING CONTROLS (Section C405.2) C405.2.1.1 Manual interior Indicate on plans the manual control type & locations served; E1/E2 Yes C405.2.12 li htin controls Indicate of plans the 50% lighting load reduction method 9 9 provided or identify exception taken E1lE2! EM# Indicate lighti�g system automatic shut-off capability - identify E1/E2 lighting zone areas served on plans; Automatic time — - — — Yes C405.2.2.1 switch controls and �ndicate locations of override switches on plans and the areas E1/E2 override switching served, include area sq. ft.; _ Indicate locations where automatic shutoff is provided by other EZ methods (occupancy sensor, dayiight controls, etc) Yee C405.2.2.2 Occupancy sensors Indicate on plans the locations served by occupancy sensors E2 Daylight zones - Indicate vertical fenestration primary and secondary daylight EZ Yee C405.2.2.3 Vertical fenestration zone areas on plans, include sq. ft.; and skylights Indicate skylight daylight zone areas on plans, include sq. ft. NA Daylight zone Indicate on plans the locations served by daylight zone controis; E2 Ye8 C405.2.2.3.2 �ntrols Indicate in plans the lighting load reduction (dimming) method - EZ stepped or continuous dimming Specific appiication Indicate on lans the locations served b s ecific a lication � C405.2.3 lighting controls- �ighting contols y P PP General indicate lighting control method for display and accent lighting, and display case lighting; xA C4052.3 - Display and accent items 1&2 lighting Indicate these fixtures are controlled independently from both generai area lighting and other lighting applications within the same space C4D52.3 - Hotel/motel guest Provide a lighting control device at each guest room entry for ali NA permanently installed fixtures in guest room; Item 3 rooms — _. _ Indicated whether lighting control is manual or automatic NA C405.2.3 - Supplemental task Provide automatic shut-off vacancy controls for suppiemental Item 4 lighting task lighting, including under-shelf or under-cabinet lighting �dentify eligible non-visual applications and method of lighting control_ NA C405.2.3 - Lighting for non- --- -- Item 5 visual applications �ndicate these fiutures are controlled independently from both general area lighting and other lighting applications within the same space Indicate lighting control method for lighting equipment for sale C405.2.3 - Lighting equipment or demonstration; NA Item 6 for sale or Indicate these fixtures are controlled independently from both � demonstration general area lighting and other lighting applications within the same space If egress lighting power density is greater fhan 0.05Wlft 2, C405.2.3 - Means of egress indicate method of automatic shut-off during unoccupied E2 Ye3 periods; Item 7 lighting Identify on plans the egress fixtures that function as both normal EZ and emergency means of egress illumination C405.10 Cooler and freezer Provide vacancy device or timer to turn off fixtures within 15 � minutes of unoccupancy for cooler and freezer lighting fixtures C405.11 lighting with lamp efficacy less than 40 lumens per watt xes C405.2.4 E�erior lighting Indicate on exterior lighting plans the automatic lighting control EZ controls method and locations served Exterior building Provide motion sensor controls for building grounds fuctures NA C405.6.1 grounds lighting rated at greater than 100 watts with lamp efficacy less than 60 controls lumens, or identify exception taken Identify applicable commissioning documentation requirements per Section C408 or eligibility for exception; NA C408.3 Lighting system Provide written procedures for functional testing of all automatic functional testing controls and describe the expected system response; Identify in construction documents the party responsibie for functional testing of automatic lighting controls INTERIOR LIGHTING POWER & EFFICACY Sections C405.5, C405.10, C405.11