Laserfiche WebLink
1 <br /> Structures <br /> Precast Concrete Retaining Walls, Timber Bridges <br /> including Lagging Panels <br /> Precast Concrete Roof Panels Treated Timber and Lumber 6 inch by 6 <br /> inch or larger <br /> Precast Concrete Structural Earth Walls, Welded Structural Steel (Miscellaneous) <br /> Noise Barrier Walls, Wall Panels, and <br /> Wall Stem Panels <br /> Precast Concrete Traffic Barrier <br /> 1 <br /> 2 Table 2: Items Requiring Initial Plant Approval Only <br /> Epoxy Coating of Dowels and Tiebars for Precast Concrete Blocks for Structural 1 <br /> Concrete Pavement Earth Walls <br /> Guardrail Posts and Blocks Steel Pipe Piling <br /> 3 <br /> 4 The deductions for fabrication inspection costs will be as shown in the Payment Table <br /> 5 below. <br /> 6 <br /> Zone Place of Fabrication or Inspection Site Reduction in Payment <br /> 1 Within 300 airline miles from Seattle None* <br /> 2 Between 300 and 3,000 airline miles from $700.00 per inspection <br /> Seattle day** <br /> 3 Over 3,000 airline miles from Seattle $1,000 per inspection <br /> day,** <br /> but not less than $2,500 <br /> per trip <br /> * Fabrication inspection expense does not apply for initial acceptance inspection in <br /> Zone 1. Re-inspection of items due to unacceptable workmanship or scheduling errors <br /> made by the Contractor, fabricator, or facility applying protective coatings will be <br /> assessed at $60.00 per hour but not less than $120.00 per inspection. <br /> **An inspection day includes any calendar day or portion of a calendar day spent by <br /> one inspector inspecting, on standby, or traveling to and from, a place of fabrication.An <br /> additional cost per inspection day will be assessed for each additional inspector. <br /> Reimbursement will be assessed at $280.00 per day for weekends and holidays for <br /> each on site inspector in travel status, but not engaged in inspection or travel activities <br /> when fabrication activities are not taking place. <br /> 7 <br /> 8 Where fabrication of an item takes place in more than one zone, the reduction in <br /> 9 payment will be computed on the basis of the entire item being fabricated in the farthest <br /> 10 of zones where any fabrication takes place on that item. <br /> 11 <br /> 12 The rates for Zones 2 and 3 shall be applied for the full duration of time for all <br /> 13 fabrication inspection activities, to include, but not be limited to: plant approvals, <br /> 14 prefabrication meetings, fabrication, coatings, and final inspection. When an inspection <br /> 15 is for more than one Contract the fabrication inspection costs shall be prorated as <br /> 16 determined by the Engineer. <br /> 17 <br /> I <br /> 1 <br /> AMENDMENTS TO THE 2014 STANDARD SPECIFICATIONS BOOK <br /> Revised: 8/3/15 <br />