Laserfiche WebLink
13 <br /> EXHIBIT C <br /> SITE STANDARDS, CONDITIONS AND INTERFERENCE MITIGATION <br /> REQUIREMENTS <br /> 1. Existing Site Improvements: The area of the existing.CMU construction building <br /> identified on sheet B2 as "Equipment Room Use by Others" may be used to house <br /> Lessee's equipment for up to 24 square feet of area. <br /> 2. Site Access: Lessee shall restrict access to the site to employees who have specific <br /> functions to perform at the site. Except for emergencies, access to the site shall be limited to the <br /> hours from 7 A.M to 7 PM. Monday through Friday. <br /> 3. Site Security: The site shall be fenced with a locking gate, which shall be locked <br /> whenever lessee employees are not present at the site. Lessee shall at all times work to maintain <br /> the security of the facility and of the lessors premises. <br /> 4. Interference Mitigation Requirements: All tenants within the facility are required to meet <br /> or exceed the following standards. <br /> All fixed transmitting and receiving equipment installed shall employ isolators or similar devices <br /> and band pass filtering or alternative band pass filtering (such as using window filters for <br /> broadband services like PCS) which accomplishes the same objectives. These devices are <br /> intended to minimize spurious radiation, receiver local oscillator leakage and transmitter and <br /> receiver intermodulation products. The following standards constitute the minimum <br /> requirements for use of wireless transmitting and receiving equipment. Additional protection <br /> may be required to address special circumstances. <br /> Transmitter/Receiver Filtering Standards <br /> The following transmitter/receiver filtering standards shall be observed: <br /> 1. Transmitters in the 25 to 54 Mhz range shall have a band pass filter providing a minimum of <br /> 30 dB of attenuation 1.0 Mhz removed from the operating frequency. Transmitters in this <br /> frequency range should be fitted with a single isolator providing a minimum of 20 dB isolation. <br /> 2. Transmitters in the 72 to 76 Mhz range shall have a band pass filter providing a minimum of <br /> 30 dB of attenuation 1.0 Mhz removed from the operating frequency. Transmitters in this <br /> frequency range shall also be fitted with dual isolators providing a minimum of 50 dB isolation. <br /> 3. Transmitters in the 88 to 108 Mhz range shall have a band pass filter providing a minimum of <br /> 30 dB of attenuation 1.0 Mhz removed from the operating frequency. Transmitters in this <br /> frequency range shall also be fitted with dual isolators providing a minimum of 50 dB isolation. <br /> No transmitters with a transmitter power output of over 100 watts shall be permitted within <br /> SERS facilities. In addition, some facilities may not allow use of transmitting equipment in this <br /> Page 27 of 30 <br /> 108 <br />