1402 SE EVERETT MALL WAY TOP NAILS 2016-01-01 MF Import

( Everett �U6L/C L�/ORKS � ENGINEERING / PUBLIC SERV/CES DEPARTMENT 1 I I I I.I 2002 August 18, 200d Kevin C. Mai 1-102 SE Everet[ Mall Way Suite #7B Evere[[, WA 98208 Project: Top Nails Job Address: 1402 SG Everett ivlall Way Plan Review No: B0408-025 Dear Mr. Mai: In response to your application for a construction pennit, your plans have been examined and you are advised that the issuance of n permit is being withheld for the reasons listed below. These commen[s address Uuilding issues only. Additional mvisions or additions may be required Uy other departmenls (such as Utilities, Planning or Pire). All references refer to die 2003 Intemational Builcfing Code, as amended by the State oF Washingcon and/or the Washington State Energy Code, 2003 edition, unless noted odiernise. This review does not cover submitted mechmiical, sprinkler, electrical or plumbing documents — diese permits must Ue obtained separately and may require further review and submission of plans. In order for the processing of your applicalian to continue, it will be necessury to provide the Building Division with two complete new sets of drawings retlecting the corrections requested. 1) The plans should be prepared and sealed by 1n architect licensed by the State oP Washington. RCW 18.08.410 ?) Based on die proposed plan, the occupant load is greater than 50. Sec[ion 1004.2 a) An exit sign should be shown at the rear exit. Section 1011.1 b) The rear halhvay should be a minimum of �4�4" wide. Section 1016.2 3) The toile[ room should have approved flooring cove up the wall a minimum of 6". Applied rubber/vinyl bases are not permitted. Section 1210.1 4) An accessible maneuvering clearance should be provided at the rear exit. It should extend a minimum of d8" perpendicular to the door and 54" parallel to die door (side approach). ICC/ANSI Al 17.1-98 Section 404.2.4.1 CITY OF EVERETi • 3200 Cedar Sireet • Everett, WA 98201 •(425) 257-8200 • Fax (425) 257-8856 I/�,