215 SW EVERETT MALL WAY EVERETT POWER SPORTS 2018-01-02 MF Import

C (. Everett Powersports Plan Check No.: B0005-026 4) The one -hour occupancy separation between the B (showrooms) and S-3 areas should be revised as noted below:... p) See revised door schedule Sheet A7. 1-hour note has been added to door N9. fler Ccj""'S '�i/ All occupancy walls have been labeled on plans. See revised sheet A2 & A3. c) 1-hour occupancy separation f oor/ceiling assembly has been added to Jthose floor areas where occupancy separation walls are not continuous vertically. Please see revised plans A2, A3, bldg. section on A5, and added / section 4/A8 for construction information. v d) Please see attached NER-200, section 3.5.2 Assembly B for 1-hour TJI Joist floor -ceiling construction. See detail 4/A8 for floor construction information. el The walls/columns supporting the 1-hour floor/ceiling assembly have been revised to reflect 1-hour construction. See added detail 5/A8 for 1-hour column wrap assembly and general note N4 on sheet A2. Please note that detail 5/A8 is based upon UL Design 0OX528. f) All duct penetrations through the occupancy separation walls & floor/ceiling assemblies will have smoke/fire dampers installed per Sections 713.10 & 713.11, no exceptions taken. Mechanical contractor to submit final engineered mechanical design drawings to you for review & approval prior to construction. 5) The sprinkler room is not consistent with the size and location requirements noted in Everett Standard 523 (attached). The sprinkler has been relocated to provide direct access from the exterior of the building and resized to accommodate the double check detector valve assembly. 1/6) Details for the removable guardrail should be provided Calculations verifying the loads required by Table 16-B should be included. Section 509. Please see added detail WAS for guardrail construction information and attached / structural calculation as requested. 7) Fire Blocking should be shown at the intersection of the interior walls and the dropped ceiling (see details I/A7). Section 708.2.1. See revised detail 1/A7 and building section 2/A5 for required fire blocking.