4901 FOWLER AVE 2018-01-02 MF Import

COMPLIANCE I rVbitUMSIDENTIAL C0MPL1ANCFF4ECK:1ST:.:'- REQUIRED Er INSPECTION PPROVEIMPORTANT: DO NOT place cheeks In the two left columns. AD FINAL PHASE t(Continued), ❑ ❑ az Exposed foam Insulation shall comply as follows (S. 502.1.4.7): ❑ Protected with metal or plastic flashing, or other suitable material that extends below grade. ❑ Insulation is approved for sub -grade, exterior use and property Installed. ❑ 1 0❑ ®Airflow between fresh air ports and the whole -house fan ensured by undercut doors/gdlls(VIAQ,S. 302.6.4) ❑ ®Looseflll insulation OK If (8.502.1.4.5): ❑ maximum ceiling slope not > 3 In 12 ❑> 30" o1 clear distance from top of bottom chord to underside of roof sheathing at the roof ridge. ❑ f mil black polyethylene ground cover, shall be lapped 12" at joints and extend to foundation wall ❑ ❑ Clearances shall meet listed minimums between insulation and (S.502.1.4.3): ❑ chimney ❑Non -IC rated recessed lights: 1/2" to combustables, 3" to insulation. ❑ Z ttic hatch shall be insulated to required ceiling R-value and is weatherstripped (S.502.1.4.4) ❑ Attic access shall have wood dam or equivalent to retain loose fill insulation In attic(S. 502.1.4.4) ❑ II exterior doors (except 20 minute doors) shall be weatherstripped (S. 502.4.3). ❑ n Service hot & cold water piping in unconditioned spaces shall be Insulated to R-3(S. 503.11) ❑ Service recirculation hot water piping in unconditiored spaces shall be insulated to Table 5-12 levels. ❑ ❑ z Heat pump thermostat shall have progamable capability (S. 503.8.3.5) ❑ ET hennostat provided for each HVAC system with range of 55-75' R(heating) (S.503.8.1.1). ❑Readily accessible, automatic or Manual means provided to restrict or shut-off Heating input to each zone or floor during periods not requiring heat (S. 503.8.3.1). ❑ s ntrols for backup heat prohibit similtaneous operation of the primary system (S. 503.2.2(3)). El 6 chanicai ventilation system shall have proper timers, and/or switches (VIAQ, S. 302.3). ❑ echanlcal ventilation ducts shall have R-4 insulation in uncon_ d_tioned spaces (VIAQ, S. 302.5) ❑ a echanlcal ventilation supply ducts in conditioned spaces shall have R-4 insulation (VIAQ, 302.5) ❑ upply ducts shall have volume dampers, or the equivalent, to balance system (S. 503.6). ❑ upply and return air ducts shall have sealed duct joints in unconditioned spaces (S. 503.10.2). ❑ VAC plenums, supply, and return air ducts shall have R-8 insulation (Table 5-11, All options) ❑ ❑ lectric water heater(s) shall have (S. 504.2.1. 504.3, 504.4) : ❑ separate power . shut-off ❑ 1987 NAECA Lable on tank ❑ noncompressible R10 pad (unheated s aces only) ❑ Temperature setting s 120 F. ❑ howers and lavatories shall limit flow to sgallons/minute (S. 504.8.1). ❑ ❑ EDSwlmming pools(S. 504.5) shall have: Z,rj ❑ readily accessible ON/OFF swftch (pump, heater) ❑Pool cover ❑Piping insulated to S. 503.11 ❑ ❑ ®s All fireplaces (VIAQ, S. 402.3) shall have: ❑ 6 square inch combustion air suppiyduet w/ accessible damper directly connected to the fire box ❑ Tight fitting glass or metal doors. ❑ Tight fitting flue damper ❑ ❑ s Solid fuel burning appliance(s) (VIAQ, S. 402.2) shall have: ❑Tight fitting glass or metal doors ❑Outside combustion air source directly connected to the fire box ❑ Exception: Non -direct, 4" diameter, dampered, combustion air source: allowed only for (1) new stove installations in existing homes where obstructionspreciudes direct combustion air, or (2) Central heating systems located in unheated spaces.- INO 0 D Three month, etched track radon monitor, printed instructions, and information sheets shall be supplied to the single family dwelling or first floor units of multi -family dwellings by the qspqpsi.eeter (VIAQ,S. 502.2.1), .luRl solc,-rloN. WSEC Final phase requirements: Inspected by` _Dare Page 6 of 6 — - -_---Date._