Laserfiche WebLink
State Nonresidential <br />•nce <br />Code CorOience <br />Project Info <br />Project Address 31 SE Everett Meal way, tat 2 <br />Date 9/6/2007 <br />Everett, WA 98201 <br />For Building Department Use <br />Applicant Name, Dlaanaians, Inc. <br />Applicant Address: 3006 Northup Way, 4302, aellavvo, WA 98004 <br />Applicant Phone. 426-827-9293 <br />Prn;nr+ 11lncrrinfinn 12 New Building ❑ Addition ❑ Alteration ❑ Change of Use <br />0 Prescriptive ❑ Component Performance ❑ Seattle EnvStd <br />Compliance Option (See Decision Flowchart (over) for qualifications) ❑ Systems Analysis <br />Space Heat Type <br />Q Electnc resistance QQ All other (see over for definitions) <br />Total Glazing Area Electronic version. these values are automatically taken from ENV-UA-1. <br />Glazing Area Calculation <br />(rough opening) Cross Extenor <br />Note: Below grade walls may be included in the <br />(vertical & overhd) divided by Wall Area times 100 equals % Glazing <br />Gross Extenor Well Area if they are insulated to <br />1426.7 — 6516. 7 X 1 �� = 21 • 9 <br />the level required for opaque walls. <br />Q yes Check here if using this option and it project meets all requirements for the Concrete/Masonry <br />Coneret iaSOn Option <br />ry p <br />Option See Decision Flowchart (over) for qualifications Enter requirements for each qualifying <br />Y" <br />Q no assembly below. <br />O yes Check here if using semi heated path and if project meets all requirements for semi heated spaces <br />Semi -Heated Path as defined in section 1310 Requires other fuel heating and qualifying thermostat Only wall <br />O n0 in <br />insulation requirement is reduced (20D6 change) Only available prescriptive path. <br />Envelope Requirements (enter values as applicable) <br />Minimum Insulation R-values <br />Roofs Over Attic <br />All Other Roofs <br />R-21 <br />Opaque Walls' <br />R-19 <br />Below Grade Walls <br />Floors Over Unconditioned Space <br />Slabs -on -Grade <br />R-10 <br />Radiant Floors <br />Maximum U-factors <br />Opaque Doors <br />0.600 <br />Vertical Glazing <br />0.550 <br />Overhead Glazing <br />Maximum SHGC (or SC) <br />VerticallOverhead Glazing 0.450 <br />1. Assemblies with metal framing must comply with overall U-factors <br />Notes: <br />Opaque Concrete/Masonry Wall Requirements <br />Wall Maximum U-factor Is 0.15 (R5.7 continuous ins) <br />CMU block walls with insulated cores comply <br />If project qualifies for Concrete/Masonry Option, list walls <br />with HC z 9.0 Blulfta°F below (other walls must meet <br />Opaque Wall requirements). Use descriptions and values <br />from Table 10-9 in the Code. <br />Wall Description U-factor <br />(including insulation R-value & position) <br />\1 4 <br />