Laserfiche WebLink
Project Info <br />Project Address <br />35 SE Everett w11 Nay, smite 101 <br />Date 2/2/2009 <br />Everett, NA 98201 <br />For Building Department Use <br />Applicant Name. <br />Echelbargar Properties <br />Applicant Address::.16108 <br />Ash way. 4203 Lynnwood,) xw:9e087 <br />Applicant Phone. <br />(425): 7a1-3535 <br />Project Description <br />❑ New Building ❑ Addition Q Alteration ❑ Plans Included <br />Refer to WSEC Section 1513 for controls and commissioning requirements. <br />Compliance Option <br />Q Prescriptive Q Lighting Power Allowance Q Systems Analysis <br />(See Qualification Checklist (over). Indicate Prescriptive & LPA spaces clearly on plans ) <br />Alteration Exceptions <br />(check appropriate box - sec. 1132.3) <br />JEJ No changes are being made to the lighting <br />❑ Less than 60% of the fixtures new, install°,+ :,altage not increased, & space use not changed. <br />Maximum Allowed Lighting Wattage <br />Location <br />(floor/room no <br />Occupancy Description <br />Allowed <br />Watts per ft2 " <br />Area in It2 <br />Allowed x Area <br />T2.0 <br />office. <br />1.06 <br />991.0 <br />1050.5 <br />T2.0 <br />restroom <br />1.00 <br />47.0 <br />67.0 <br />•' From Table 15-1 (over) - document all exceptions on form LTG-LPA Total Allowed Watts <br />1097.5 <br />Prnnnsed Liehtine Wattaee <br />Location <br />(Boodroom no <br />Fixture Description <br />Number of <br />Fixtures <br />Watts/ <br />Fixturo <br />Watts <br />Proposed <br />T2.0 office <br />2:I 54030tubo:flour.ecent <br />12 <br />85.0 <br />1020.0 <br />T2.0 ra.troom <br />41010tubeOflouroecent <br />1 <br />56.0 <br />56.0 <br />Total Proposed Watts may not exceed Total Allowed Watts for Interior Tota: Proposed Watts <br />1076.0 <br />Notes: <br />1. For proposed Fixture Description, indicate fixture type, lamp type (e.g. T-8), number of lamps in the fixture, and ballast type (if <br />included). For track lighting, list the length of the track (in feel) in addition to the fixture, lamp, and ballast information. <br />2. For proposed Watts/Fixture, use manufacturers listed maximum input wattage of the fixture (nc. simply the lamp wattage) and <br />other criteria as specified in Section 1530. For hard -wired ballasts only, the default table in the NREC Technical Reference Manual <br />may also be used. For track lighting, list the greater of actual luminaire wattage or length of track multiplied by 50, or as applicable <br />the wattage of current limiting devices or of the transformer. <br />3. List all fixtures. For exempt lighting, note section and exception number, and leave Watts/Fixture blank. <br />Ig <br />