5904 LARIMER RD 2018-01-02 MF Import

COMPLIANCE rr j r REQUIRED 6 INSPECTIO APPROVED IMPORTANT: Disregard topics that don't describe your building orequlpment. DO NOT place checks In the two left columns. s � ❑ e Airflow from habitable rooms to whole -house fan ensured by undercut doors or grills (VIAQ, S. 302.6.4) ❑ ❑ ®i Looseflll insulation OK if (S.502.1.4.5): ❑maximum ceiling slope Z3 in 12 0 030" of clear distance from lop of bottom chord to underside of roof sheathing at the roof ridge. mll black polyethylene ground cover, lapped 12" at joints and to foundation wall ❑ Clearances shall meet listed minhilums between Insulation and (S.502.1.4.3)! ❑ chimney ❑ Non -IC rated re;essed lights: 1/2" to combustables, 3" to insulation. ❑ ❑ ttic hatch shall be insulated to required ceiling R-value and is weatherstripped (S.502.1.4.4) ❑ ❑ AH[c access shall have wood dam or equivalent to retain loose fill insulation in attic (S. 502.1.4.4) ❑ LMJAII exterior doors (except 20 minute doors) shall be weatherstripped (S. 502.4.3). ❑ 7 Service hot & cold Pater piping shall be insulated to R-3 S. 503.11) ❑ Service recircwatlon hot water piping shall be insulated to Table 5-12 levels. ❑ hermostat provided for each HVAC system with range of 55-75' F.(heating) (S.503.8.1.1). ❑ o Readily accessible, automatic or Manual means provided to restrict or shut-off Heating Input to each zone or floor during periods not requiring heat (S. 503.8.3.1). ❑ ❑ r Controls for backup heat prohibit simillaneous operation of the primary system (S. 503.2.2(3)). ❑ z Mechanical ventilation systems shall have proper timers, and/or switches (S. 302.3). I.p s Mechanical ventilation ducts shall have insulation t R-4 in unconditioned spaces (VIAQ, S. 302.5) ❑ Mechanical supply ducts in conditioned spaces shall have a R-4 insulation (VIAQ, S. 302.5) ❑ s upply ducts shall have volume dampers, or the equivalent, to balance system (S. 503.6). ❑ ❑ e Supply and return air ducts shall have sealed duct joint,, in unconditioned spaces (S. 503.10.2). ❑ ❑ HVAC plenums, supply, and return air ducts shall have R-8 insulation (Table 5-11. All options) ❑ a Eiectri�water heater(s) shall have (S.504.2.1, 504.3, 504.4) separate power shut-off 1S1g87 NAECA Lable on tank I Koncompressible R10 pad (unheated spaces only) C!rTemperature setting s 120 F. ❑ s Showers and lavatories shall limit flow to snl0ftallons/minute (S. 504.8.1). ❑ ❑ o Swimming pool(s) (S. 504.5) shall have: 44 Z, ❑ readily accessible ON/OFF switch (pump, heater) ❑ Pool cover ❑ Piping insulated to S. 503.11 ❑ ❑ r Fireplace(s) (VIAQ, S. 402.3) shall have: ❑ 6 square inch combustion air supplyduct w/ operable damper, directly connected to the fire box ❑ Tight fittirg glass or metal doors; or flue draft induction fan. ❑ Tight tilting flue damper. ❑ ❑ z Solid fuel burning appliance(s) (VIAQ, S. 402.2) shall have: ❑ Tight fitting glass or metal doors ❑ Outside combustion air source directly connected to the fire box '10 ❑ Exception: Non -direct, 4" diameter, tampered, combustion air source: allowed only for (1) new stove installations in existing homes where obstructions preclude direct combustion air, or (2) Central heating systems located in unheated spaces. ❑ 9 Three month, etched track, radon monitor, printed instructions, and an information sheet shall be supplied by the Iw4d"to each single family dwelling and to each ground floor unit of mufti -family dwellings (VIAQ, S. 502.2.1). J URt sr/ c.>/anr WSEC Final phase requirements: Inspecfed by Page 6 of 6