2621 HILLSIDE LN 2018-01-02 MF Import

y COMPLIANCE REOUIRED 0 I b O O In O O O O 0 [71 INSPECnON IMPORTANT: Dn_b= place ctrecks In the two left columns. APPROVED PHASEFINAL (Contintied) p © Exposed foam Insulation shall comply as follows (S. 502.1.4.7): ❑ Protected with metal or plastic flashing, or other suitable material that extends below grade. ❑ Insulation is approved for sub -grade, exterior use and property Installed. p EDAIrflow between fresh air ports and the whole -house fan ensured by undercut doors/grffls(VWO,S. 302.6.4) O E)Looseflll Insulation OK 1(S.502.1 A.5): dmaximum ceiling slope not > 3 in 12 t2r:1�30' of clear distance from top of bottom chord to underside of roof sheathing at the roof ridge. O �mll black polyethylene ground cover, shall be lapped 12" at joints and extend to foundation wall O learances shall meet listed minimums between insulation and (S.502.1.4.3): Mchimney ❑Non -IC rated recessed lights:1/2" to combustables, 3" to insulation. p PAUlc hatch ahall be Insulated to required ceiling R-value and is weatherstripped (S.502.1.4.4) pPservice ttic access shall have wood dam or equivalent to retain loose fill insulation in attic(S. 502.1.4.4) p11 exterior doors (except 20 minute doors) shall be weatherstripped (S. 502.4.3). Q ervice hot & cold water piping in unconditioned spaces shall be Insulated to R-3(S. 503.11) p recirculation hot water piping in unconditioned spaces shall be insulated to Table 6-12 levels. C3 n2 Heat pump thermostat shall have progamable capability (S. 503.8.3.5) p z Thermostat provided for each HVAC system with range of 55-75' R(heating) (S.503.8.1.1). pmjReadily accessible, automatic or Manual means provided to restrict or shut-off Heating input to each zone or floor during periods not requiring heat (S. 503.8.3.1). p s ontrols for backup heat prohibit similtaneous operation of the primary system (S. 503.2.2(3)). p s echanical ventilation system s;Iall have proper timers, and/or switches (VIAO, S. 302.3). t] ventilation ducts shall have R-4 insulation in unconditioned spaces (VIAO, S. 302.5) ElRachanical achanlcal ventilation supply ducts in Gunditionad spaces shall have R-4 insulation (VIAO, 302.5) p uppiy ducts shall have volume dampers, or the equivalent, to balance system (S. 503.6). p @DSupply and return air ducts shall have sealed duct joints in unconditioned spaces (S. 503.10.2). p r VAC plenums, supply, and return air ducts shall have FI-8 insulation (Table 5-11, All options) ❑ a lectric water heaters) shall have (S. 504.2.1. 504.3, 504.4) : ❑ separate power shut-off ❑ 1987 NAECA Lable on tank ❑ noncompressible R10 pad (unheated spaces only) ❑ Temperature settings 120 F. O �howers and lavatories shall limit flow to s 3.0 gallonsiminute (S. 504.8.1). p wimming pools(S. 504.5) shall have: ❑ readily accessible ON/OFF switch (pump, heater) ❑Pool cover ❑Piping insulated to S. 503.11 p @DAll fireplaces (VIAO, S. 402.3) shall have: ❑ 6 square inch combustion air supplyduct w/ accessible damper directly connected to the fire box ❑ Tight fitting glass or metal doors. ❑ Tight fitting flue damper p s Solid fuel burning appllanoe(s) (VIAO, S. 402.2) shall have: ❑Tight fitting glass or metal doors ❑ Outside combustion air source directly connected to the fire box ❑ Exception: Non -direct, 4" diameter, dampered, combustion air source: allowed only for (1) new stove installations in existing homes where obstructionsprecludes direct combustion air, or (2) Central heating systems located in unheated spaces. E] @D Three month, etched track radon monitor, printed Instructions, and Information sheets shall be supplied to the single family dwelling or first floor units of multi -family dwellings by the general contractor (VIAO,S. 502.2.1), Page 6 of 6 WSEC Final phase requirements: \Inspected by: _ Data