2715 HARRISON AVE 2018-01-02 MF Import

COMPUANCE REQUIRED INsPEcnoN IMPORTANT: Disregard topics that don't describe your building or equipment. 00 NOT APPROVED place checks In the two left columns. } ❑ Airflow from habitable rooms to whole -house fan ensured by undercut doors or grills (VIAQ, S. 302.6.4) ❑ M LoosefIII insulation OK If (S.502.1.4.5): ❑maximum ceiling slope L3 in 12 M 30" of clear distance from top of bottom chard to underside of roof sheathing at the roof ridge. �[ ❑ mil black polyethylene ground cover, lapped 12" at joints and to foundation wall ❑ UClearances shall meet listed minimums between insulation and (S.502.1.4.3): r3 chimney ❑ Non -IC rated recessed lights: 1/2" to combustables, 3" to insulation. ❑ gAttic ic hatch shall be insulated to required ceiling R-value and is weatherstripped (S.502.1.4.4) ❑ access shall have wood dam or equivalent to retain loose fill Insulation in attic (S. 502.1.4.4) II exterior doors (except 20 minute doors) shall be weatherstripped (S. 502.4.3). ❑ 7 Service hot & cold water piping shall be Insulated to R-3 (S. 503.11) ❑ JFRIeadlly ervice recirculation hot water piping shall be insulated to Table 5-12 levels. El hemostat provided for each HVAC system with range of 55-75' F.(heating) (S.503.8.1.1). ❑ accessible, automatic or Manual means provided to restrict or shutoff Heating Input to each zone or floor during periods not requiring heat (S. 503.8.3.1). r ❑ r Controls for backup heat prohibit similtaneous operation of the primary system (S. 503.2.2(3)). ❑ 2 Mechanical ventilation systems shall have proper timers, and/or switches (S. 302.3). ❑ a Mechanical ventilation ducts shall have Insulation x R-4 in unconditioned spaces (VIAQ, S. 302.5) JM ❑ Mechanical supply ducts In conditioned spaces shall have z R-4 insulation (VIAQ, S. 302.5) ❑ s upply ducts shall have volume dampers, or the equivalent, to balance system (S. 503.6). ❑ Supply and return air ducts shall have sealed duct joints in unconditioned spaces (S. 503.10.2). ❑ x HVAC plenums, supply, and return air ducts shall have R-8 insulation (Table 5-11, All options) ❑ Electric water heater(s) shall have (S. 504.2.1, 504.3, 504.4) Aseparate power shutoff t':1 1987 NAECA Lable on tank prnonoompressible R10 pad{unheated spaces only) ;' Temperature setting s 120 F. (� ❑ 9 Showers and lavatories shall limit flow to s 3.0 gallons/minute (S. 504.8.1). ❑ ❑ Swimming pool(s) (S. 504.5) shall have: ❑readily accessible ONIOFF switch (pump, heater) ❑ Pool cover ❑ Piping insulated to S. 503.11 ❑ ❑ r Fireplace(s) (VIAQ, S. 402.3) shall have: ❑ 6 square inch combustion air supplyduct w/ operable damper, directly connected to the fire box p Tight fitting glass or metal doors; or flue draft Induction fan. ❑ Tight fitting flue damper. O O 2 Solid fuel burning appliance(s) (VIAQ, S. 402.2) shall have: o Tight fitting glass or metal doors ❑ Outside combustion air source directly connected to the fire box ❑ Exception: Non -direct, 4" diameter, dampered, combustion air source: allowed only for (1) new stove installations in existing homes where obstructions preclude direct combustion air, or (2) Central heating systems located in unheated spaces. ❑ ❑ a Three month, etched track, radon monitor, printed instructions, and an information sheet shall be supplied by the builder to each single family dwelling and to each ground floor unit of multi -family dwellings (VIAQ, S.502.2.1). WSEC Final phase requirements: Inspected by Date Page 6 of 6