1716 PUGET DR 2016-01-01 MF Import

PUBLIC WORKS PERMIT COMMENTS 4. As per Public Wor':s approved plan dated 5. Connect side sewer per City Standard #601. � Connect side sewer per Ciry Standard #'s 601, 602, 604. 7. Connect all rooftop downspouts to the side sewer. 8. Connect rooftop downspouts to the drainage system provided for this lot. � Rookop runoff must be discharged to a roof downspout infiltration system per City of Everett Storm Manual 3-2.6.2. Width �, Depth a' , Length f9'. 10. A catch basin as per City Standard Plan #402 with a gas trap per Standard Plan #410 is required for the parking area. 11. Remove and replace curb, gutter and sidewalk as per City of Everett Standard Plan #'s 305A & 306 on this proposal's frontage as directed by the Public Works Inspector (i.e. all unused driveways and any broken or damaged area must be replaced). 12. Install a Type I concrete driveway per City of Everett Standard #307. 13. Pave driveway from the front property line out to the stree4 paving. 14. Contact the Water District for connecting provisions ror this building's water and sewer services. 15. If a sewer pump system is to be installed, the pressure line must discharge into a private manhole, then graviiy flow across the public right-of-way. 16. The contractor must meet with the Public Works Inspector to discuss potential drainage routing prior to beginning the project. 17. A sprinkler system is required for this building in compliance with the requirements of NFDA Standards 13D. �. All excavated material from foundation, sidewalk and driveways shall be hauled to an approved, permitted site. No wasting of material is allowed on this building lot. 19. Install erosion control measures as determined by the Public Works inspector, such as silt fence, straw bales, swales, or erosion blankets. � Remove erosion control measures upon completion of the project prior to final approval of the permit. � Install erosion control measures per City of Everett Standards for small parcels. PWComments � � � 7 �(o Pc��i�--� 1�-�-