4433 RIDGEMONT DR 2016-01-01 MF Import

C CC 6C sa v C a� � WATTSUN 5.3 COMPONENT CHECKLIST 02/26/93 FILE: C:\WATTSUN5\WSFILES\0593022.WS HOUSE ID: ADDITION insulation fille all exterior wall�cavities. It is not compressed and ie cut to fit around wires, pipea, and outlet boxes. Receased fixtures in exterior walls have at least R-5 insulation behind them. _ Va�lted ceiling: (R-36 SATT VAULT VENTED 2X12 255.0 ft2) Insulation is instal.led to the manufacturer's recommended density and coveraqe without compression. Solar: (Light Frame, Sheetrock walls 688.0 ft2) Thermal mass is directly exposed to conditioned space and is located within the space containing the solar glass, or an approved heat transfer mechanism is provided. Mass is covered by finish material of R-1 or less. Ducts: (Return Ducts: Attic or qarage R8 27.5 ft2) All HVAC ducts installeft outside the heated, habitable space are sealed at joints, corners, and boots, and insulated to the specified value. Vapor retarder: 1.o perm or less vapor retarder (e.g. poly, kraf` paper, perm rated paint) 1s installed on the warm side of insulation in floors, ceilings and walls. _ A O.F perm vapor barrier is installed on all vaulted ceilinqs. Recessed lights: Any recessed light fixtures in the thermal envelope are certified under ASTM E-283 and labeled showing compliance, or are sealed around the exterior to be air tight. FINAL INSPECTION ---------'-------"_-------'-----'---------'------------------------------- Crawl space moisture barrier: A six mil black polyethelene ground cover is installed on crawlspace floor. Flaor Insulation: (R38 unvented Enclosed 400.0 ft2; insulation is supported in a permanent manner without compression. Pipe insulation: All �oater pipes in unheated spaces are insulated to R-3. Hot water: Electric water heater labeled as meeting ASHRAE Standard 90A-1980 or 1987 NAECA. Tank has R-10 non-compressible pad underneath if ____==�==a��=��_��___________________ Page 2 =___________________�_______�------