1510 SE EVERETT MALL WAY 2018-01-01 MF Import

f. Where directed by the Fire Code Official, specific areas shall be designated and those areas are to be marked with diagonal striping across the width of the fire lane. Diagonal marking shall be used in conjunction with painted curbs and/or edge striping and shall run at an angle of 30 to 60 degrees from one side to the other. These diagonal lines shall be in red traffic paint, parailel with each other, at least 6 inches in width and 24 inches apart. Lettering shall appear as above. 5. Fire Hvdrants - Locations as planned are acceptable. 6. Premise Identification - Premises shall be clearly identified by the correct address at the street entry. Buildings shall be clearly identified so as to be visible and legible from the access road. Individual apartments and suites, where applicable, shall be clearly and legibly identified from the access ad. _See EMC 16.03, Section 505.1.'. (Address Posting Policy). mYi�e 10-inch building numbers with 4-inch suite numbers. 7. Fire flow for this project is 1,500 gpm. 8. Fire Alarm Svstem - An approved automatic fire detection system shall be provided as required by City Ordinance No. 3021-07, Chapter 16.76, of the Everett Municipal Code. Plans for such system shall be submitted to the Fire Code O�cial for review and approval prior to installation. Submittal shall include cut sheets of ali equipment intended for use. Appropriate trip tests, witnessed by a Fire Department Inspector, shall be performed, along with a certificate of completion, prior to final acceptance of the system. Fire alarm systems shall be installed according to NFPA Chapter 72. Installation of fire alarm components, including basic wiring, may not commence before plans are approved by the Fire Department Plan Reviewer. Fire alarm drawings must be professionally rendered, in sufficient detail, and must be internally consistent. Riser diagrams must match installation plans and load calculations. Components must be listed and approved for use together. Changes to plans must include new drawings and calculations and must be approved by the Fire Depaitment Plan Reviewer prior to installation. Fire alarm installation is subject to field inspection by a Fire Dep�. tment inspector. An approved set of pians and the Engineering & Public Services Department electrical permit must be present for any instaliation inspection. Fire alarm systems shall be installed under permit of the City of Everett Engineering & Public Services Department. Glectrical inspections and approval are required prior to calling for acceptance tests. Call (425) 257-8810 for permit information. T;ie absence of working phone lines for the alarm system will be cause for postponing Fire Uepartment inspection and testing and shall result in denial of occupancy. A copy of NFPA 72 Record of Completion form must be filled out prior to final occupancy (NFPA 72, 2007 Edition, page 72-33). Call for design requirements per Authority Having Jurisdiction. Automatic smoke detection is required.