4602 W VIEW DR 2018-01-02 MF Import

COMPLIANCE ' REQUIRED N INSPECTION IMPORTANT: DO NOT place checks In the two Jett Columns. APPROVED ❑ ❑ Q Exposed foam Insulation shall comply as follows (S. 502.1.4.7): ❑ Protected with metal or plastic flashing, or other suitable material that extends below grade. ❑ Insulation is approved for sub -grade, exterior use and property Installed. ❑ ❑ ®Airflow between fresh air ports and the whole -house fan ensured by undercut doors/gdlis(VIAQ,S. 302.6.4) ❑ ❑ ©i Looseflll !nsulation OK if (S.502.1.4.5): ❑ maximum ceiling slope not > 3 in 12 ❑a 30' of clear distance from top of bottom chord to underside of roof sheathing at the roof ridge. ❑ ❑ mil black polyethylene ground corer, shall be lapped 12" at Joints and extend to foundation wall ❑ [3 Clearances shall meet listed minimums between insulation and (S.502.1.4.3): ❑ chimney ❑Non -IC rated recessed lights: 1/2" to combustables, 3" to Insulation. ❑ ❑ EDAttic hatch shall be insulated to required ceiling R-value and is wealherstripped (S.502.1.4.4) ❑ ❑ @flAffIc access shall have wood dam or equivalent to retain loose fill insulation in attic(S. 502.1.4.4) ❑ ❑ W9 1AII exterior doors (except 20 minute doors) shall be weatherstripped (S. 502.4.3). ❑ ID Service hot & cold water piping in unconditioned spaces shall be Insulated to R-3(S. 503.11) ❑ [3 r Service recirculation hot water piping in unconditioned spaces shall be insulated to Table 5-12 levels. ❑ ❑ @Heat pump thermostat shall have progamable capability (S. 503.8.3.5) ❑ ❑ UJThermostat provided for each HVAC system with range of 55-75' F.(heating) (S.503.8.1.1). ❑ ❑ Readily accessible, automatic or Manual means provided to restrict or shut-off Heating input to each zone or floor during periods not requiring heat (S. 503.8.3.1). ❑ ❑ @DControls for backup heat prohibit similtaneous operation of the primary system (S. 503.2.2(3)). ❑ ❑ s hanical ventilation system shall have proper timers, and/or switches (VIAQ, S. 302.3). El ❑ a chemical ventilation ducts shall have R-4 insulation in unconditlon .d spaces (VIAQ, S. 302.5) ❑ ❑ a chanlcal ventilation supply ducts in nonditioned spaces shall have R-4 insulation (VIAO, 302.5) ❑ Elupply ducts shall have volume dampers, or the equivalent, to balance system (S. 503.6). ❑ [3upply and return air ducts shall have sealed duct joints in unconditioned spaces (S. 503.10.2). Elr ❑ VAC plenums, supply, and return silt ducts shall have R-8 insulation (Table 5-11, All options) ❑ ❑ z Iectric water heater(s) shall have (S. 504.2.1. 504.3, 504.4) : ❑ separate power . shut-off ❑ 1987 NAECA Lable on tank ❑ noncompressible R10 pad (unheated spaces only) ❑ Temperature setting s 120 F. ❑ ❑ showers and lavatories shall limit flow to c 3.0 gallons/minute (S. 504.8.1). ❑ ❑Swimming pools(S.504.5) shall have: ❑ readily accessible ON/OFF switch (pump, heater) ❑Pool cover ❑Piping insulated to S. 503.11 O ❑ Ail fireplaces (VIAQ, S. 402.3) shall have: ❑ 6 square inch combustion air supplyduct w/ accessible damper directly connected to the fire box ri Tight fitting glass or metal doors. ❑ Tight fitting flue damper L3 ❑ e Solid fuel burning appliance(s) (VIAQ, S. 402.2) shall have: ❑Tight fitting glass or metal doors ❑Outside combustion air source directly connected to the fire box ❑Exception: Non -direct, 4" diameter, dampered, combustion air source: allowed only for (1) new stove installations in existing homes where obstructionsprecludes direct combustion air, or (2) Central heating systems located in unheated spaces. ❑ p FD Three month, etched track radon monitor, printed instructions, and information sheets shall be supplied to the single family dwelling or first floor units of multi -family dwellings by the general contractor (VIAO,S. 502.2.1), WSEC Final phase requirements: Inspecttai by Page 6 of 6