|
COMPUANCE
<br />RE�UIRED �
<br />❑
<br />❑
<br />❑
<br />❑
<br />❑
<br />0
<br />�
<br />��
<br />0
<br />�
<br />�
<br />■
<br />�1
<br />JI
<br />n
<br />INSPECTION
<br />APPROVED �MPORTANT: Please supply Inf�rtnatlon In the shaded boxes and check the approprlate
<br />� clrcles. Dlsrepard toplcs that don't descrlbe you� butlding or equlpment. DO NOT place
<br />checks In the two left columns.
<br />❑
<br />❑
<br />❑
<br />❑
<br />❑
<br />I�G
<br />rNsutanoNptr,as�
<br />�„ 6JJ Exterlor slab Insutetion, il not located on the interior, shall be R-10 (Table 6-2).
<br />] Exterlor slab Insulation, il present, shall approved lor below grade use and protected above grade.
<br />��Wells, including rim joists, shali be insulated wfthout cOtnpreSsiott to 'Teble 6-2):
<br />{�ii-15 batl (Options l,lq �R-19 (Option lll, IV, V, VI, VII) +
<br />]Intet(or betow grade waiis shall be insula[�d wiihout compression to (Ta61e 8•2):
<br />QR•15 (Options I, Iq ' �R•19 (Optionslil, IV, V, Vl, VA}
<br />��Vaulted cellings shali be insulated without compression to R-3D (Table &2, All optia ,)
<br />Skylight wall insulatlon is installed and equivalent to ihe required wall R-values above.
<br />❑ Q Vepor retarders shall be Installed toward tfie warm surface as represented be�wv (502>t:sjc
<br />Seiect one option tor iloors, walis, and appropriate ceiiings:
<br />Floors: � Plywood W! exterior glue �j Yoly (z 4 Mil) � BaCked batts
<br />Walis: Poty p�astiC (� 4 Mil) � Faa.-slapled, backed betts � PVA peint `
<br />Ceilings: Not required where verriiiatio� space averages >72" above insulation.
<br />Face stapied backedbatts �jPoly piasC�c (a 4 mii) � PVA paiM
<br />❑ 3 Hoating system efficiency and sizlnp requirements shall be met as represented below:
<br />❑ g Heat Pump efilclency shail be met under the following compliance path (5. 503.d):
<br />� Split system, alr Source heat pump: HSPF2 6.8, COP > 3A
<br />O Singie packa9e, air source heatpump: HSPF a 8.6; COP > 3.0
<br />� Water source heat pump: COP a 3.8
<br />�• Ground source heat pump COP 2 3A `
<br />❑ QQ Central force•alr furnace AFUE rating, as listed in the GAMA pirectory, shall be:
<br />��� a.78 (Options I, II, IV, VI, Vlq � z.88 (Option Iil}} 02„74 (Option Vj
<br />❑ Qe Non-central, combustlon heating systems shau have intermhent ignition
<br />❑ p�]Maximum heaQng system output {150%of design heat Ioad} is_ BT'Umr. (5.5032.2)
<br />❑�e Hlgh efllclency forcetl•air furnace (s 56,900 BTU/hc output)may may exceed ]50°Ioot-0Hl
<br />because: QGAMA listed AFUE is 2 78 + t per each 5000 BTU/hr output Ihat it exCeeds the pHL
<br />WSEC lnsulation phase requirements:
<br />lnspected by:
<br />����e€� .����x� x"� °`� �,
<br />W ,� � � ..,.'v ��F� ' ;r,�»'�v„
<br />Date
<br />❑ � Envelope Floors shaH be insulated witlwut compression, and with support s z4" O.C. to�
<br />{QR79 (Options 1,JI, III, IV, V) Q R25 (Options VI, Vtlj
<br />❑ �o Non•vaulted, attic cellings shall be insulatod without compresslon to: `
<br />QR•30 (Optlons I, II, III, IV, V, Vlp C, n3g �pptlon VIj See Table 6-2_
<br />❑ Q Door systems shall meet:Q U.40 (Aii options)
<br />Door types are (1) {2) �3)
<br />Page 5 cf 6
<br />
|