11830 19TH AVE SE 2016-01-01 MF Import

APPLICATION/COVERAGE/CLEAN-UP: There are four general rules to observe when n-�� ,r .. _ �., with ATCO A1402 Copper Preservative: 1. The more solution that is applied and ak the more effective the treatment. 2. Sawn ends as well as other exposed end and crosscut grain should receive extra attention and protection because they are more �usceptible to damage. 3. ATCO A1902 Copper Preservatfve will not be satiafactorily absorbed into wet or frozen surfaces, including unseasoned wood surfaces. 4. Follow label directions carefully and observe the pre- cautions that are outlined on the label. ATCO A1402 Copper Preservative may be applied by dipping, � brushing or rolling. This product can be aprayed but it is not recommended since the spray particles may be irritating to the eyes, nose and throat, as well as damaging to vegetation. Dip method: In order to obtain maximum effectiveness, the item that is to�ee treated should be totally immersed into ATCO #1402 � Copper Preservative. Fence posts and other similar items can be treated by immersing the end in an open head 55-gallon drum, then inverting and immeraing the opposite end. If only the portion of the pole or post from ap- proximately 6 inches above the ground line to the underground base needs to be treated, a single end dip process may be used. This , method should only be used with durable woods and/or in dry climates. For total immersion dipping of lumber and siding, a simple metal or wood trough lined with heavy polyethylene film is adequate for the job. Immersion time dependa on the species of wood and the severity of exposure the treated wood is expected to encounter. In addition, the seasoning of the wood and wood temperature are factors to be taken into consideration. For estimating purposes: limited exposure wood (siding, trim � lumber, etc. ) needs approximate y to minutes of immersion. Wood subjected to moderate exposure (mud sills, plates, etc. ) should be dipped 90 to minu es. Finally, wood that will be exposed to ' seve.re exposure requires 36 to 42 houra of treatment. In all cases, a ona mmersion time will increase the preservative's effec- tiveness.