105 58TH PL SW 2016-01-01 MF Import

WATTSUN 5.4A COMPONENT CHECKLIST 03/02/94 FILE: C:\\WATTSUNS\\NEWFILE HOUSE ID: The Tamarack, Model "B" Name: Arthur & Judith Ruben Floor Area: 1654 ft2 Address: 105 58th Place, SW Heating Type: Gas Furnace Reference: 1991 WA State Energy Code -------------------------------------------------------------------------------- FOUNDATION INSPECTION --------------------------------------------------------------------------- Sub-slab radon requirement: [ ] Where required, slab is poured over a 4" thick coarse gravel base. A 6-mil poly soil gas retarder membrane is installed between the gravel and slab. All tears, seams, and joints in membrane are sealed. A radon vent pipe of at least 3" in diameter runs from each separate gravel area to 12" above eaves. Slab perimeter insulation: (R10 2 , horizontal w/TB 140.0 ft) Insulation is installed from the top of the slab downward to the bottom of the slab, and then run horizontally. Slab is thermally broken from slabs in adjacent unconditioned spaces (e.g. garage) . Slab Sealing: All penetrations, cracks and joints in concrete slab or walla are sealed with a urethane type sealant to limit the movement Of soil gases into the indoor air. FRAMING INSPECTION ------------- ------------------------------------------------------ Approved plans: Are available onsiteby checking with the Superintendent. Air leakage: Soleplate is caulked or glued to subfloor. Rim joists between stories are caulked/sealed. All holes in building envelope (i.e. exterior ceilings, walls, and floors) are caulked/sealed, including all electrical, plumbing, and HVAC penetrations. Outlets, switch boxes and recessed fixtures on exterior walls are caulked/sealed with approved sealant, or have foam face gaskets installed. Any recessed lights are IC rated, air tight, and sealed to the ceiling sheetrock. Wall framing: Net wall area: 2220 ft2 Page mmmm�