Laserfiche WebLink
b. PERCOLATION TESTS <br /> At least 3 holes required. <br /> 1. Dig test hole at least' 36 inches deep in the drainfield area. <br /> 2. Fill hole with water. Now let all water run out of hole. This soaks the <br /> ground and will give a more accurate reading. <br /> 3. Again pour water in hole to a height of. 12 inches from the bottom. Let water <br /> run out until there is just 6 inches from bottom left in hole. <br /> 4. vote how many minutes it takes for this last 6 inches to seep away. <br /> Perform the above procedure for each of the. 3 holes and record results below. <br /> Teat hole U1 Test hole 02_ Test hole #3_ <br /> I hereby certify they above information to be correct and the above tests were <br /> performed by me as prescribed on (Oate) <br /> Signed_ <br /> Address <br /> Show a complete demensioned plot plan, location, size, shape and placement of the <br /> building on the building site showing its relation to the sewage disposai system to <br /> be instnlled. <br /> f <br /> e <br /> NOTE: A septic tank permit is issued on the basis of the above information. If <br /> there are any changes or alterations in th-z above stated soil conditions it may <br /> result in the installation being rejected at the time of inspection. <br /> Do not write below these lines. 7 <br /> Average percolation rate on which to base drainfield design. J <br /> Septic tank size C gallons. Amount of sq. ft. of disposal field '9 0 U d f <br />