116 73RD ST SW 2018-01-02 MF Import

COMPLIANCE REQUIRED V M 0 0 INSPECTION IMPORTANT: QQ�iQI place checks in the two left columns. APPROVED ❑ Exposed foam Insulation shall comply as follows (S. 502.1.4.7): ❑ Protected with metal or plastic flashing, or other suitable material that extends below grade. ❑ Insulation is approved for sub -grade, exterior use and properly Installed. ❑ (DAlrflow between fresh air ports and the whole -house fan ensured by undercut doors/grills(VIAQ,S. 302.6.4) ❑ ©° Loosefill Insulation OK if (S.502.1.4.5): ❑ maximum ceiling slope not > 3 in 12 ❑ a 30" of clear distance from top of bottom chord to underside of roof sheathing at the roof ridge. ❑ g6 mil black polyethylene ground cover, shall be lapped 12" at Joints and extend to foundation wall [3 Clearances shall meet listed minimums between insulation and (S.502.1.4.3): ❑ chimney ❑ Non -IC rated recessed lights: 1/2" to combuslables, 3" to Insulatior. ❑ hatch shall be Insulated to required calling R-value and is weatherstripped (S.502.1.4.4) ❑lAttic Attic access shall have wood dam or equivalent to retain loose fill Insulation in attic(S. 502.1.4.4) ❑ All exterior doors (except 20 minute doors) shall be weatherstripped (S. 502.4.3). Service hot & cold water piping In unconditioned spaces shall be Insulated to R-3(S. 503.11) ❑ Service recirculation hot water piping in unconditioned spaces shall be Insulated to Table 5-12 levels. ❑ QQ2 Heat pump thermostat shall have progamabfe capability, (S. 503.8.3.5) ❑ pa]Thermostat provided for each HVAC system with range of 55-75' R(heating) (S.503.8.1,1). ❑ Reacilly accessible, automatic or Manual means provided to restrict or shut-o" Heating Input to each zone or floor during periods not requiring heat (S. 503.8.3.1). ❑ 11upply ontrols for backup heat prohibit similtaneous operation of the primary system (S. 503.2.2(3)). ❑ echanical ventilation system shall have proper timers, and/or switches (VIAQ, S. 302.3). ❑ echanlcal ventilation ducts shall have R-4 Insulation in iinc r _onditloned spaces (VIAQ, S. 302.5) Elechanical ventilation supply ducts in condillanod spaces shall have R-4 insulation (%IAO, 302.5) ❑ ducts shall have volume dampers, or the equivalent, to balance system (S. 503.6). ❑ o upply end return air ducts shall have sealed duct Joints in unconditioned spaces (S. 503.10.2). ❑ 1 VAC plenums, supply, and return air ducts shall have R-8 insulation (Table 5-11, All options) ❑ z lectrlc water heater(s) shall have (S. 504.2.1, 504.3, 504.4) : 0 separate power shut-off ❑ 1987 NAECA Lable on tank ❑ noncompressible R10 pad (unheated spaces only) ❑ Temperature setting s 120 F. ❑ showers and lavatories shall omit flow to s 3.0 gallons/minute (S. 504.8.1). ❑ ®Swimming pools(S. 504.5) shall have: ❑ readily accessible ON/OFF switch (pump, heater) ❑Pool cover ❑Piping insulated to S. 503.11 ❑ QAII fireplaces (VIAQ, S. 402.3) shall have: ❑ 6 square inch combustion air supplyduct w/ accessible damper directly connected to the fire box ❑ Tight fitting glass or metal doors. ❑ Tight filling flue damper ❑ e Solld fuel burning applience(s) (VIAO, S. 402.2) shall have: ❑Tight fitting glass or metal doors ❑ Outside combustion air source directly connected to the fire box ❑ Exception: Non -direct, 4" diameter, tampered, combustion air source: allowed only for (1) new stove installations in existing homes where obstructionsprecludes direct combustion air, or (2) Central healing systems located in unheated spaces. ❑PThree month, etched track radon monitor, printed Instructions, and Information sheet; shall be supplied to the single family dwelling or first floor units of multi -family dwellings by the general contractor (VIAQ,S. 502.2.1), Page 6 of 6 WSEC Final phase requirements: Inspected by: Date —�