830 80TH ST SW DIEBOLD INC 2018-01-02 MF Import

Project Info Project Address D1ebo1e, tne. Date 6/5/2007 eso Seth at err, ate 100 For Building Department Use Everett, MA Applicant Name. Applicant Address Applicant Phone ProjectDescription I[] New Building ❑Addition ❑Alteration [D Change of Use ❑ prescriptive Q Component Performance El Systems Analysis Compliance Option (See Decision Flowchart (over) for qualifications) Space Heat Type O Electric resistance * All other (see over for definitions) Total Glazing Area Electronic version these values are automatically taken from ENV-UA-1. Glazing Area Calculation (rough opening) Gross Exterior Note. Below grade want may be included In the (vertical d overhd) divided by Wall Area times 100 equals % Glazing 1260.5 - 5956.0 X100= 21.2% Gross Exlenor Wall Area if they are insulated to the level required for opaque walls Concrete/Masonry Option Q yes Check here if using this option and it project meets all requirements for the Concrete/Masonry Option. See Decision Fkwchart(over) for qualificatio,is Enter requirements for each qualtfymg O no assembly below. Envelope Requirements fenter values as applicable) Fully heatedlicooled space Minimum Insulation R-values I Roofs Over Attic All Other Roofs Opaque Walls' Below Grade Walls Floors Over Unconditioned Space Floors Maximum Doors Glazing id Glazing I Maximum SHGC (or SO I Glazing Semi -heated space a Minimum Insulafon R•velues Roofs Over Semi -Heated Spectral I 1. Assemblies with metal framing must comply with overall Udactors 2. Refer to Section 1710 for qualifications and requirements Notes: See Envelope Summary Opaque ConcretelfiAasonry Wall Requirements Wall Maximum U•factor Is 0.15 (R5.7 continuous ins) CMU block walls with Insulated cares comply with HC 2 9.0 BIWIIs-' F below father walls must meet Opaque Wall requirements). Use descriptions and values from Table 10.9 in the Code. Wall Description U-factor (including insulation R-value & positron)